| Common Name: | HEAT SHRINK TUBING MW |
| Manufacturer: | 3M |
| SDS Revision Date: | 6/11/2014 |
| SDS Format: | OTHER INFORMATION SHEET |
| Item Number(s): | 1YMK7, 5HC25, 5HC39, 5HC40, 5HC41, 5HC46, 5HC47 |
| Manufacturer Model Number(s): |
SDS Table of Contents
Click the desired link below to jump directly to that section in the SDS.
3M(TM) HEAT SHRINK TUBING MW
06/11/14
3M
ARTICLE INFORMATION SHEET
COPYRIGHT, 2014, 3M COMPANY.
ALL RIGHTS RESERVED. COPYING AND/OR DOWNLOADING OF THIS INFORMATION FOR
THE PURPOSE OF PROPERLY UTILIZING 3M PRODUCTS IS ALLOWED PROVIDED THAT:
(1) THE INFORMATION IS COPIED IN FULL WITH NO CHANGES UNLESS PRIOR WRITTEN
AGREEMENT IS OBTAINED FROM 3M, AND
(2) NEITHER THE COPY NOR THE ORIGINAL IS RESOLD OR OTHERWISE DISTRIBUTED
WITH THE INTENTION OF EARNING A PROFIT THEREON.
THIS ARTICLE INFORMATION SHEET IS PROVIDED AS A COURTESY IN RESPONSE TO
A CUSTOMER REQUEST. A SAFETY DATA SHEET (SDS) HAS NOT BEEN PREPARED FOR
THESE PRODUCT(S) BECAUSE THEY ARE ARTICLES. ARTICLES ARE NOT SUBJECT TO
THE OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION'S HAZARD COMMUNICATION
STANDARD (29 CFR 1910.1200(B)(6)(V)).
AS DEFINED IN THIS STANDARD:
"ARTICLE" MEANS A MANUFACTURED ITEM OTHER THAN A FLUID OR PARTICLE:
(I) WHICH IS FORMED TO A SPECIFIC SHAPE OR DESIGN DURING MANUFACTURE;
(II) WHICH HAS END USE FUNCTION(S) DEPENDENT IN WHOLE OR IN PART UPON ITS
SHAPE OR DESIGN DURING END USE; AND (III) WHICH UNDER NORMAL CONDITIONS
OF USE DOES NOT RELEASE MORE THAN VERY SMALL QUANTITIES, E.G., MINUTE OR
TRACE AMOUNTS OF A HAZARDOUS CHEMICAL, AND DOES NOT POSE A PHYSICAL OR
HEALTH RISK TO EMPLOYEES.
DOCUMENT GROUP: 06-2030-2
VERSION NUMBER: 1.00
ISSUE DATE: 06/11/14
SUPERCEDES DATE: INITIAL ISSUE
| SECTION 1: IDENTIFICATION |  |
1.1. PRODUCT IDENTIFIER: 3M(TM) HEAT SHRINK TUBING MW
1.2. RECOMMENDED USE AND RESTRICTIONS ON USE:
RECOMMENDED USE: ELECTRICAL, PROTECTION OF ELECTRICAL CONNECTION
1.3. SUPPLIER'S DETAILS:
MANUFACTURER: 3M
DIVISION: ELECTRICAL MARKETS DIVISION
ADDRESS:
3M CENTER
ST. PAUL, MN 55144-1000
USA
TELEPHONE: 1-888-3M HELPS (1-888-364-3577)
1.4. EMERGENCY TELEPHONE NUMBER:
1-800-364-3577 OR (651) 737-6501 (24 HOURS)
| SECTION 2: HAZARD IDENTIFICATION | |
THIS PRODUCT IS EXEMPT FROM HAZARD CLASSIFICATION ACCORDING TO OSHA HAZARD
COMMUNICATION STANDARD. 29 CFR 1910.1200.
| SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS | |
INGREDIENT C.A.S. NO. % BY WT
ADHESIVE-LINED POLYOLEFIN TUBING MIXTURE 100
| SECTION 4: FIRST AID MEASURES | |
4.1. DESCRIPTION OF FIRST AID MEASURES:
INHALATION: NO NEED FOR FIRST AID IS ANTICIPATED.
SKIN CONTACT: NO NEED FOR FIRST AID IS ANTICIPATED.
EYE CONTACT: NO NEED FOR FIRST AID IS ANTICIPATED.
IF SWALLOWED: NO NEED FOR FIRST AID IS ANTICIPATED.
| SECTION 5: FIRE-FIGHTING MEASURES | |
IN CASE OF FIRE:
USE A CARBON DIOXIDE OR DRY CHEMICAL EXTINGUISHER TO EXTINGUISH.
| SECTION 6: ACCIDENTAL RELEASE MEASURES | |
6.1. PERSONAL PRECAUTIONS, PROTECTIVE EQUIPMENT AND EMERGENCY PROCEDURES:
NOT APPLICABLE.
6.2. ENVIRONMENTAL PRECAUTIONS: NOT APPLICABLE.
6.3. METHODS AND MATERIAL FOR CONTAINMENT AND CLEANING UP: NOT APPLICABLE.
| SECTION 7: HANDLING AND STORAGE | |
7.1. PRECAUTIONS FOR SAFE HANDLING: AVOID SKIN CONTACT WITH HOT MATERIAL.
7.2. CONDITIONS FOR SAFE STORAGE INCLUDING ANY INCOMPATIBILITIES:
NO SPECIAL STORAGE REQUIREMENTS.
| SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION | |
THIS PRODUCT IS CONSIDERED TO BE AN ARTICLE WHICH DOES NOT RELEASE OR
OTHERWISE RESULT IN EXPOSURE TO A HAZARDOUS CHEMICAL UNDER NORMAL USE
CONDITIONS. NO ENGINEERING CONTROLS OR PERSONAL PROTECTIVE EQUIPMENT
(PPE) ARE NECESSARY.
| SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES | |
9.1. INFORMATION ON BASIC PHYSICAL AND CHEMICAL PROPERTIES:
GENERAL PHYSICAL FORM: SOLID
SPECIFIC PHYSICAL FORM: TUBE
ODOR, COLOR, GRADE: BLACK TUBING, VARIOUS SIZES, ODORLESS
ODOR THRESHOLD: NOT APPLICABLE
PH: NOT APPLICABLE
MELTING POINT: NO DATA AVAILABLE
BOILING POINT: NOT APPLICABLE
FLASH POINT: NO FLASH POINT
EVAPORATION RATE: NOT APPLICABLE
FLAMMABILITY (SOLID, GAS): NOT CLASSIFIED
FLAMMABLE LIMITS(LEL): NOT APPLICABLE
FLAMMABLE LIMITS(UEL): NOT APPLICABLE
VAPOR PRESSURE: NOT APPLICABLE
VAPOR DENSITY: NOT APPLICABLE
SPECIFIC GRAVITY: 1.0 [DETAILS: MITS DATA]
SOLUBILITY IN WATER: NOT APPLICABLE
SOLUBILITY - NON-WATER: NOT APPLICABLE
PARTITION COEFFICIENT N-OCTANOL/WATER: NO DATA AVAILABLE
AUTOIGNITION TEMPERATURE: NO DATA AVAILABLE
DECOMPOSITION TEMPERATURE: NOT APPLICABLE
VISCOSITY: NOT APPLICABLE
VOLATILE ORGANIC COMPOUNDS: NOT APPLICABLE
PERCENT VOLATILE: NOT APPLICABLE
VOC LESS H2O & EXEMPT SOLVENTS: NOT APPLICABLE
| SECTION 10: STABILITY AND REACTIVITY | |
THIS MATERIAL IS CONSIDERED TO BE NON REACTIVE UNDER NORMAL USE CONDITIONS.
| SECTION 11: TOXICOLOGICAL INFORMATION | |
INHALATION: NO HEALTH EFFECTS ARE EXPECTED
SKIN CONTACT: NO HEALTH EFFECTS ARE EXPECTED
EYE CONTACT: NO HEALTH EFFECTS ARE EXPECTED
INGESTION: NO HEALTH EFFECTS ARE EXPECTED
ADDITIONAL INFORMATION:
THIS PRODUCT, WHEN USED UNDER REASONABLE CONDITIONS AND IN ACCORDANCE WITH
THE DIRECTIONS FOR USE, SHOULD NOT PRESENT A HEALTH HAZARD. HOWEVER, USE OR
PROCESSING OF THE PRODUCT IN A MANNER NOT IN ACCORDANCE WITH THE PRODUCT'S
DIRECTIONS FOR USE MAY AFFECT THE PERFORMANCE OF THE PRODUCT AND MAY
PRESENT POTENTIAL HEALTH AND SAFETY HAZARDS.
| SECTION 12: ECOLOGICAL INFORMATION | |
THIS ARTICLE IS EXPECTED TO PRESENT A LOW ENVIRONMENTAL RISK EITHER BECAUSE
USE AND DISPOSAL ARE UNLIKELY TO RESULT IN A SIGNIFICANT RELEASE OF
COMPONENTS TO THE ENVIRONMENT OR BECAUSE THOSE COMPONENTS THAT MAY BE
RELEASED ARE EXPECTED TO HAVE INSIGNIFICANT ENVIRONMENTAL IMPACT.
| SECTION 13: DISPOSAL CONSIDERATIONS | |
DISPOSE OF CONTENTS/CONTAINER IN ACCORDANCE WITH THE LOCAL/REGIONAL/
NATIONAL/INTERNATIONAL REGULATIONS.
| SECTION 14: TRANSPORT INFORMATION | |
FOR TRANSPORT INFORMATION, PLEASE VISIT:
HTTP://3M.COM/TRANSPORTINFO OR CALL 1-800-364-3577 OR 651-737-6501.
| SECTION 15: REGULATORY INFORMATION | |
CHEMICAL INVENTORIES:
THIS PRODUCT IS AN ARTICLE AS DEFINED BY TSCA REGULATIONS, AND IS EXEMPT
FROM TSCA INVENTORY REQUIREMENTS.
| SECTION 16: OTHER INFORMATION | |
NFPA HAZARD CLASSIFICATION:
HEALTH 0
FLAMMABILITY 1
INSTABILITY 0
SPECIAL HAZARDS NONE
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA) HAZARD RATINGS ARE DESIGNED
FOR USE BY EMERGENCY RESPONSE PERSONNEL TO ADDRESS THE HAZARDS THAT ARE
PRESENTED BY SHORT-TERM, ACUTE EXPOSURE TO A MATERIAL UNDER CONDITIONS OF
FIRE, SPILL, OR SIMILAR EMERGENCIES. HAZARD RATINGS ARE PRIMARILY BASED ON
THE INHERENT PHYSICAL AND TOXIC PROPERTIES OF THE MATERIAL BUT ALSO INCLUDE
THE TOXIC PROPERTIES OF COMBUSTION OR DECOMPOSITION PRODUCTS THAT ARE KNOWN
TO BE GENERATED IN SIGNIFICANT QUANTITIES.
DOCUMENT GROUP: 06-2030-2
VERSION NUMBER: 1.00
ISSUE DATE: 06/11/14
SUPERCEDES DATE: INITIAL ISSUE
DISCLAIMER:
THE INFORMATION IN THIS ARTICLE INFORMATION SHEET (AIS) IS BELIEVED TO BE
CORRECT AS OF THE DATE ISSUED. 3M MAKES NO WARRANTIES, EXPRESSED OR
IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR COURSE OF
PERFORMANCE OR USAGE OF TRADE. USER IS RESPONSIBLE FOR DETERMINING WHETHER
THE 3M PRODUCT IS FIT FOR A PARTICULAR PURPOSE AND SUITABLE FOR USER'S
METHOD OF USE OR APPLICATION. GIVEN THE VARIETY OF FACTORS THAT CAN AFFECT
THE USE AND APPLICATION OF A 3M PRODUCT, SOME OF WHICH ARE UNIQUELY WITHIN
THE USER'S KNOWLEDGE AND CONTROL, IT IS ESSENTIAL THAT THE USER EVALUATE
THE 3M PRODUCT TO DETERMINE WHETHER IT IS FIT FOR A PARTICULAR PURPOSE AND
SUITABLE FOR USER'S METHOD OF USE OR APPLICATION.
3M PROVIDES INFORMATION IN ELECTRONIC FORM AS A SERVICE TO ITS CUSTOMERS.
DUE TO THE REMOTE POSSIBILITY THAT ELECTRONIC TRANSFER MAY HAVE RESULTED
IN ERRORS, OMISSIONS OR ALTERATIONS IN THIS INFORMATION, 3M MAKES NO
REPRESENTATIONS AS TO ITS COMPLETENESS OR ACCURACY. IN ADDITION,
INFORMATION OBTAINED FROM A DATABASE MAY NOT BE AS CURRENT AS THE
INFORMATION IN THE AIS AVAILABLE DIRECTLY FROM 3M.
3M USA AISS ARE AVAILABLE AT WWW.3M.COM