| Common Name: | TURBOKRETE PART A, 5494A |
| Manufacturer: | RUST-OLEUM |
| SDS Revision Date: | 2/8/2007 |
| SDS Format: | No Format Specified |
| Item Number(s): | 6KP53 |
| Manufacturer Model Number(s): | 5494-323 |
SDS Table of Contents
Click the desired link below to jump directly to that section in the SDS.
MATERIAL SAFETY DATA SHEET
24 HOUR ASSISTANCE: 1-847-367-7700
RUST-OLEUM CORP.
WWW.RUSTOLEUM.COM
| SECTION 1 - CHEMICAL PRODUCT / COMPANY INFORMATION |  |
PRODUCT NAME: TURBOKRETE PART A
REVISION DATE: 02/08/2007
IDENTIFICATION NUMBER: 5494A
PRODUCT USE/CLASS: CONCRETE REPAIR/EPOXY
SUPPLIER:
RUST-OLEUM CORPORATION
11 HAWTHORN PARKWAY
VERNON HILLS, IL 60061
USA
MANUFACTURER:
RUST-OLEUM CORPORATION
11 HAWTHORN PARKWAY
VERNON HILLS, IL 60061
USA
PREPARER: REGULATORY DEPARTMENT
| SECTION 2 - COMPOSITION / INFORMATION ON INGREDIENTS | |
CHEMICAL NAME CAS NUMBER WEIGHT % LESS THAN
BIS-A LIQUID EPOXY RESIN 25085-99-8 75.0
FURFURYL ALCOHOL 98-01-1 20.0
TITANIUM DIOXIDE 13463-67-7 5.0
CHEMICAL NAME ACGIH ACGIH OSHA OSHA
TLV-TWA TLV-STEL PEL-TWA PEL-CEILING
BIS-A LIQUID EPOXY N.E. N.E. N.E. N.E.
RESIN
FURFURYL ALCOHOL 10 PPM SKIN N.E. 10 PPM SKIN N.E.
TITANIUM DIOXIDE 10 MG/M3 N.E. 10 MG/M3 N.E.
| SECTION 3 - HAZARDS IDENTIFICATION | |
EMERGENCY OVERVIEW:
CAUSES EYE IRRITATION. CAUSES SKIN IRRITATION. MAY CAUSE ALLERGIC SKIN
REACTION. COMBUSTIBLE LIQUID AND VAPOR.
EFFECTS OF OVEREXPOSURE - EYE CONTACT:
SUBSTANCE CAUSES SEVERE EYE IRRITATION. INJURY MAY BE PERMANENT.
EFFECTS OF OVEREXPOSURE - SKIN CONTACT:
MAY CAUSE SKIN SENSITIZATION, AN ALLERGIC REACTION, WHICH BECOMES EVIDENT
ON RE-EXPOSURE TO THIS MATERIAL.
EFFECTS OF OVEREXPOSURE - INHALATION:
HIGH VAPOR CONCENTRATIONS ARE IRRITATING TO THE EYES, NOSE, THROAT AND
LUNGS.
EFFECTS OF OVEREXPOSURE - INGESTION: SUBSTANCE MAY BE HARMFUL IF SWALLOWED.
EFFECTS OF OVEREXPOSURE - CHRONIC HAZARDS:
REPORTS HAVE ASSOCIATED REPEATED AND PROLONGED OCCUPATIONAL OVEREXPOSURE
TO SOLVENTS WITH PERMANENT BRAIN AND NERVOUS SYSTEM DAMAGE.
PRIMARY ROUTE(S) OF ENTRY: SKIN CONTACT, SKIN ABSORPTION, EYE CONTACT
| SECTION 4 - FIRST AID MEASURES | |
FIRST AID - EYE CONTACT:
HOLD EYELIDS APART AND FLUSH WITH PLENTY OF WATER FOR AT LEAST 15 MINUTES.
GET MEDICAL ATTENTION.
FIRST AID - SKIN CONTACT:
WASH WITH SOAP AND WATER. GET MEDICAL ATTENTION IF IRRITATION DEVELOPS
OR PERSISTS.
FIRST AID - INHALATION:
REMOVE TO FRESH AIR. IF NOT BREATHING, GIVE ARTIFICIAL RESPIRATION. IF
BREATHING IS DIFFICULT, GIVE OXYGEN. GET IMMEDIATE MEDICAL ATTENTION.
FIRST AID - INGESTION:
IF SWALLOWED, DO NOT INDUCE VOMITING. GIVE VICTIM A GLASS OF WATER OR MILK.
CALL A PHYSICIAN OR POISON CONTROL CENTER IMMEDIATELY. NEVER GIVE ANYTHING
BY MOUTH TO AN UNCONSCIOUS PERSON.
| SECTION 5 - FIRE FIGHTING MEASURES | |
FLASH POINT (SETAFLASH): 185 F
LOWER EXPLOSIVE LIMIT: N.A. %
UPPER EXPLOSIVE LIMIT: N.A. %
EXTINGUISHING MEDIA: DRY CHEMICAL, FOAM, WATER FOG
UNUSUAL FIRE AND EXPLOSION HAZARDS: COMBUSTIBLE LIQUID AND VAPOR.
SPECIAL FIREFIGHTING PROCEDURES:
FULL PROTECTIVE EQUIPMENT INCLUDING SELF-CONTAINED BREATHING APPARATUS
SHOULD BE USED. WATER MAY BE USED TO COOL CLOSED CONTAINERS TO PREVENT
PRESSURE BUILDUP AND POSSIBLE AUTOIGNITION OR EXPLOSION. EVACUATE AREA
AND FIGHT FIRE FROM A SAFE DISTANCE.
| SECTION 6 - ACCIDENTAL RELEASE MEASURES | |
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED:
REMOVE ALL SOURCES OF IGNITION, VENTILATE AREA AND REMOVE WITH INERT
ABSORBENT AND NON-SPARKING TOOLS. ISOLATE THE HAZARD AREA AND DENY ENTRY
TO UNNECESSARY AND UNPROTECTED PERSONNEL. DISPOSE OF ACCORDING TO LOCAL,
STATE (PROVINCIAL) AND FEDERAL REGULATIONS. DO NOT INCINERATE CLOSED
CONTAINERS.
| SECTION 7 - HANDLING AND STORAGE | |
HANDLING:
WASH THOROUGHLY AFTER HANDLING. AVOID BREATHING VAPOR OR MIST. AVOID
PROLONGED OR REPEATED CONTACT WITH SKIN. USE ONLY IN A WELL-VENTILATED
AREA. FOLLOW ALL MSDS/LABEL PRECAUTIONS EVEN AFTER CONTAINER IS EMPTIED
BECAUSE IT MAY RETAIN PRODUCT RESIDUES.
STORAGE:
DO NOT STORE ABOVE 120 DEG. F. STORE LARGE QUANTITIES IN BUILDINGS DESIGNED
AND PROTECTED FOR STORAGE OF NFPA CLASS II COMBUSTIBLE LIQUIDS. KEEP
CONTAINERS TIGHTLY CLOSED. ISOLATE FROM HEAT, ELECTRICAL EQUIPMENT, SPARKS
AND OPEN FLAME.
| SECTION 8 - EXPOSURE CONTROLS / PERSONAL PROTECTION | |
ENGINEERING CONTROLS:
PREVENT BUILD-UP OF VAPORS BY OPENING ALL DOORS AND WINDOWS TO ACHIEVE
CROSS-VENTILATION. USE PROCESS ENCLOSURES, LOCAL EXHAUST VENTILATION, OR
OTHER ENGINEERING CONTROLS TO CONTROL AIRBORNE LEVELS BELOW RECOMMENDED
EXPOSURE LIMITS.
RESPIRATORY PROTECTION:
A NIOSH/MSHA APPROVED AIR PURIFYING RESPIRATOR WITH AN ORGANIC VAPOR
CARTRIDGE OR CANISTER MAY BE PERMISSIBLE UNDER CERTAIN CIRCUMSTANCES WHERE
AIRBORNE CONCENTRATIONS ARE EXPECTED TO EXCEED EXPOSURE LIMITS.
PROTECTION PROVIDED BY AIR PURIFYING RESPIRATORS IS LIMITED. USE A
POSITIVE PRESSURE AIR SUPPLIED RESPIRATOR IF THERE IS ANY POTENTIAL FOR
AN UNCONTROLLED RELEASE, EXPOSURE LEVELS ARE NOT KNOWN, OR ANY OTHER
CIRCUMSTANCES WHERE AIR PURIFYING RESPIRATORS MAY NOT PROVIDE ADEQUATE
PROTECTION.
SKIN PROTECTION:
NITRILE OR NEOPRENE GLOVES MAY AFFORD ADEQUATE SKIN PROTECTION. USE GLOVES
TO PREVENT PROLONGED SKIN CONTACT.
EYE PROTECTION:
USE SAFETY EYEWEAR DESIGNED TO PROTECT AGAINST SPLASH OF LIQUIDS.
OTHER PROTECTIVE EQUIPMENT:
REFER TO SAFETY SUPERVISOR OR INDUSTRIAL HYGIENIST FOR FURTHER INFORMATION
REGARDING PERSONAL PROTECTIVE EQUIPMENT AND ITS APPLICATION.
HYGIENIC PRACTICES:
WASH THOROUGHLY WITH SOAP AND WATER BEFORE EATING, DRINKING OR SMOKING.
REMOVE CONTAMINATED CLOTHING IMMEDIATELY AND LAUNDER BEFORE REUSE.
| SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES | |
BOILING RANGE: 500 - 500 F
VAPOR DENSITY: HEAVIER THAN AIR
ODOR: AMMONICAL
ODOR THRESHOLD: ND
APPEARANCE: LIQUID
EVAPORATION RATE: SLOWER THAN ETHER
SOLUBILITY IN H2O: SLIGHT
FREEZE POINT: ND
SPECIFIC GRAVITY: 0.939
VAPOR PRESSURE: ND
pH: NE
PHYSICAL STATE: LIQUID
(SEE SECTION 16 FOR ABBREVIATION LEGEND)
| SECTION 10 - STABILITY AND REACTIVITY | |
CONDITIONS TO AVOID: AVOID TEMPERATURES ABOVE 120 DEG. F.
INCOMPATIBILITY:
PRODUCT SLOWLY CORRODES COPPER, ALUMINUM, ZINC, AND GALVANIZED SURFACES
HAZARDOUS DECOMPOSITION:
WHEN HEATED TO DECOMPOSITION, IT EMITS ACRID SMOKE AND IRRITATING FUMES.
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR UNDER NORMAL CONDITIONS
STABILITY: STABLE UNDER NORMAL CONDITIONS
| SECTION 11 - TOXICOLOGICAL INFORMATION | |
PRODUCT LD50: ND
PRODUCT LC50: ND
CHEMICAL NAME LD50 LC50
BIS-A LIQUID EPOXY RESIN >5000 MG/KG RAT N.D.
FURFURYL ALCOHOL 275 MG/KG RAT ORAL 233 PPM RAT 4H/INH
TITANIUM DIOXIDE >7500 MG/KG (ORAL, RAT) N.D.
| SECTION 12 - ECOLOGICAL INFORMATION | |
ECOLOGICAL INFORMATION: PRODUCT IS A MIXTURE OF LISTED COMPONENTS.
| SECTION 13 - DISPOSAL INFORMATION | |
DISPOSAL INFORMATION:
DISPOSE OF MATERIAL IN ACCORDANCE TO LOCAL, STATE AND FEDERAL REGULATIONS
AND ORDINANCES. DO NOT ALLOW TO ENTER STORM DRAINS OR SEWER SYSTEMS.
| SECTION 14 - TRANSPORTATION INFORMATION | |
DOT PROPER SHIPPING NAME: PAINT
DOT TECHNICAL NAME:
DOT HAZARD CLASS: 3
DOT UN/NA NUMBER: UN1263
PACKING GROUP:
HAZARD SUBCLASS:
RESP. GUIDE PAGE:
| SECTION 15 - REGULATORY INFORMATION | |
CERCLA - SARA HAZARD CATEGORY:
THIS PRODUCT HAS BEEN REVIEWED ACCORDING TO THE EPA `HAZARD CATEGORIES'
PROMULGATED UNDER SECTIONS 311 AND 312 OF THE SUPERFUND AMENDMENT AND
REAUTHORIZATION ACT OF 1986 (SARA TITLE III) AND IS CONSIDERED, UNDER
APPLICABLE DEFINITIONS, TO MEET THE FOLLOWING CATEGORIES:
CHRONIC HEALTH HAZARD
SARA SECTION 313:
LISTED BELOW ARE THE SUBSTANCES (IF ANY) CONTAINED IN THIS PRODUCT THAT ARE
SUBJECT TO THE REPORTING REQUIREMENTS OF SECTION 313 OF TITLE III OF THE
SUPERFUND AMENDMENT AND REAUTHORIZATION ACT OF 1986 AND 40 CFR PART 372:
TOXIC SUBSTANCES CONTROL ACT:
LISTED BELOW ARE THE SUBSTANCES (IF ANY) CONTAINED IN THIS PRODUCT THAT
ARE SUBJECT TO THE REPORTING REQUIREMENTS OF TSCA 12(B) IF EXPORTED FROM
THE UNITED STATES:
U.S. STATE REGULATIONS: AS FOLLOWS
NEW JERSEY RIGHT-TO-KNOW:
THE FOLLOWING MATERIALS ARE NON-HAZARDOUS, BUT ARE AMONG THE TOP FIVE
COMPONENTS IN THIS PRODUCT.
CHEMICAL NAME CAS NUMBER
1,6 HEXANEDIOL DIACRYLATE 13048-38-4
EPOXY PIGMENT DISPERSION MIXTURE
PENNSYLVANIA RIGHT-TO-KNOW:
THE FOLLOWING NON-HAZARDOUS INGREDIENTS ARE PRESENT IN THE PRODUCT AT
GREATER THAN 3%.
CHEMICAL NAME CAS NUMBER
1,6 HEXANEDIOL DIACRYLATE 13048-38-4
CALIFORNIA PROPOSITION 65:
WARNING!
THIS PRODUCT CONTAINS A CHEMICAL(S) KNOWN BY THE STATE OF CALIFORNIA TO
CAUSE CANCER.
WARNING!
THIS PRODUCT CONTAINS A CHEMICAL(S) KNOWN TO THE STATE OF CALIFORNIA TO
CAUSE BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.
INTERNATIONAL REGULATIONS: AS FOLLOWS
CANADIAN WHMIS:
THIS MSDS HAS BEEN PREPARED IN COMPLIANCE WITH CONTROLLED PRODUCT
REGULATIONS EXCEPT FOR THE USE OF THE 16 HEADINGS.
CANADIAN WHMIS CLASS: B3 D2B
| SECTION 16 - OTHER INFORMATION | |
HMIS RATINGS:
HEALTH 2*
FLAMMABILITY 2
REACTIVITY 0
PERSONAL PROTECTION X
VOLATILE ORGANIC COMPOUNDS, G/L: 152
REASON FOR REVISION: REGULATORY UPDATE
LEGEND:
N.A. - NOT APPLICABLE
N.E. - NOT ESTABLISHED
N.D. - NOT DETERMINED
THE INFORMATION CONTAINED ON THIS MSDS HAS BEEN CHECKED AND SHOULD BE
ACCURATE. HOWEVER, IT IS THE RESPONSIBILITY OF THE USER TO COMPLY WITH
ALL FEDERAL, STATE, AND LOCAL LAWS AND REGULATIONS.