| Common Name: | MELTBLOWN POLYPROPYLENE ABSORBENT MATERIAL |
| Manufacturer: | WORLDWIDE SORBENT PRODUCTS |
| SDS Revision Date: | 1/1/2008 |
| SDS Format: | No Format Specified |
| Item Number(s): | 3BU42, 3BU43, 3BU44, 3BU45 |
| Manufacturer Model Number(s): |
SDS Table of Contents
Click the desired link below to jump directly to that section in the SDS.
MATERIAL SAFETY DATA SHEET
MSDS NUMBER: 00126
MSDS DATE: JANUARY 1, 2008
PRODUCT NAME: MELTBLOWN POLYPROPYLENE ABSORBENT MATERIAL
| SECTION I: IDENTIFICATION OF PRODUCT AND COMPANY INFORMATION |  |
PRODUCT NAME: MELTBLOWN POLYPROPYLENE ABSORBENT MATERIAL
CHEMICAL FAMILY: OLEFIN
CHEMICAL NAME: POLYPROPYLENE
PRODUCT TYPE: HYDROPHOBIC/HYDROPHILIC/STATIC RESISTANT
COMPANY IDENTIFICATION:
WORLDWIDE SORBENT PRODUCTS, INC.
205 LAKESHORE DRIVE
PORT ARTHUR, TEXAS 77640
409-983-7800
409-985-2566 (FAX)
| SECTION II: COMPOSITION/INFORMATION ON INGREDIENTS | |
MATERIAL:
POLYPROPYLENE < OR = 100%
PROPERTIES ADDITIVES < OR = 0.01% (TRADE SECRET)
OCCUPATIONAL EXPOSURE LIMITS: NONE ESTABLISHED BY OSHA OR ACGIH
| SECTION III: PHYSICAL DATA | |
APPEARANCE/COLOR:
WHITE: HYDROPHOBIC/OIL ONLY
BLUE: HYDROPHOBIC/OIL ONLY
GRAY: HYDROPHOBIC/UNIVERSAL
GREEN: HYDROPHOBIC/UNIVERSAL
PINK: STATIC RESISTANT/LABELED
WHITE: STATIC RESISTANT/LABELED
ODOR: VIRTUALLY ODOR FREE
SPECIFIC GRAVITY: 0.88 - 0.92
BOILING POINT: NOT APPLICABLE
MELTING POINT: >160 DEGREES CELSIUS
SOLUBILITY IN WATER: INSOLUBLE
PERCENT VOLATILE BY VOLUME: NOT APPLICABLE
EVAPORATION RATE: NOT APPLICABLE
VAPOR PRESSURE: NOT APPLICABLE
VAPOR DENSITY: NOT APPLICABLE
| SECTION IV: FIRE AND EXPLOSION HAZARD DATA | |
FLASH POINT: >329 DEGREES CELSIUS (PENSKY-MARTENS CLOSED CUP ASTM D93)
FLAMMABLE LIMITS: NOT APPLICABLE
EXTINGUISHING MEDIA: WATER, FOAM, CO2, DRY CHEMICAL
SPECIAL FIRE FIGHTING PROCEDURES: STANDARD PROCEDURE FOR CLASS "A" FIRES
UNUSUAL FIRE AND EXPLOSION HAZARDS:
SOME CARBON MONOXIDE FORMATION IS POSSIBLE UNDER OXYGEN LEAN CONDITIONS.
| SECTION V: HEALTH HAZARD DATA | |
NO SPECIAL PROCEDURES REQUIRED
| SECTION VI: STABILITY AND REACTIVITY DATA | |
THIS MATERIAL IS STABLE AND HAZARDOUS POLYMERIZATION WILL NOT OCCUR. AVOID
CONTACT WITH HOT OR CONCENTRATED NITRIC AND PERCHLORIC ACID, SULFURIC ACID
OR 98% SULFURIC ACID AT 60 DEGREES CELSIUS OR ABOVE.
| SECTION VII: SPILL OR LEAK PROCEDURES | |
COLLECT AND DEPOSIT IN A SUITABLE CONTAINER AWAY FROM HEAT AND IGNITION.
DISPOSE OF IN A SANITARY LANDFILL OR INCINERATE IN COMPLIANCE WITH STATE,
FEDERAL, AND LOCAL REGULATIONS.
| SECTION VIII: PREPARATION | |
THE INFORMATION CONTAINED HEREIN IS GIVEN IN GOOD FAITH, BUT NOT WARRANTY
EXPRESSED OR IMPLIED IS MADE.
DATE ISSUED: JANUARY 1, 2008
PREPARED BY: WSP SAFETY COMMITTEE