| Common Name: | IDENTI-PEN: BLACK(44101), BLUE(44102), RED(44103), GREEN(44104), BROWN(44105), P |
| Manufacturer: | SAKURA COLOR PRODUCTS JAPAN |
| SDS Revision Date: | 9/8/2008 |
| SDS Format: | No Format Specified |
| Item Number(s): | 3NUX4, 3NUX5, 3NUX6, 3NUX7, 3NUX8, 9YKU0 |
| Manufacturer Model Number(s): |
SDS Table of Contents
Click the desired link below to jump directly to that section in the SDS.
MATERIAL SAFETY DATA SHEET
(REQUIRED UNDER OSHA'S HAZARD COMMUNICATION STANDARD 29 CFR 1910.1200)
(44101-44108)
IDENTITY (AS USED ON LABEL AND LIST):
IDENTI-PEN:
BLACK(44101), BLUE(44102), RED(44103), GREEN(44104),
BROWN(44105), PURPLE(44106), ORANGE(44107), YELLOW(44108)
(TOTAL: 8 COLORS)
| SECTION I |  |
MANUFACTURER'S NAME: SAKURA COLOR PRODUCTS CORPORATION
ADDRESS:
1-6-20, MORINOMIYA CHUO
CHUO-KU, OSAKA, 540-8508
JAPAN
TELEPHONE NUMBER: +81 (0)6 - 6910 - 8824 (JAPAN)
FAX NUMBER: +81 (0)6 - 6910 - 8834 (JAPAN)
PUBLISHED DATE: SEPTEMBER 08, 2008
PUBLISHER: TAKAHIRO SHIRAI
| SECTION II - HAZARDOUS INGREDIENTS / IDENTITY INFORMATION | |
HAZARDOUS COMPONENTS CAS NO. WT % OSHA PEL ACGIH TLV
THIS PRODUCT IS APPROVED BY ACMI (THE ART & CREATIVE MATERIAL INSTITUTE,
INC.), AND CARRIES THE "AP" SEAL OF NON-TOXIC APPROVAL IN USA.
| SECTION III - PHYSICAL / CHEMICAL CHARACTERISTICS FOR INK | |
BOILING POINT: N.D.
SPECIFIC GRAVITY (H2O = 1 AT 25 DEG. C): 0.9
VAPOR PRESSURE (MMHg): N.D.
MELTING POINT: N.D.
VAPOR DENSITY (AIR = 1): N.D.
EVAPORATION RATE (BUTYL ACETATE = 1): N.D.
SOLUBILITY IN WATER: INSOLUBLE.
APPEARANCE AND ODOR: A LITTLE SMELL OF ETHER.
| SECTION IV - FIRE AND EXPLOSION HAZARD DATA | |
FLASH POINT (METHOD USES): 26-27 DEG. C (TAG CLOSED)
FLAMMABLE LIMITS:
LEL: N.D.
UEL: N.D.
EXTINGUISH MEDIA: IN CASE OF FIRE, USE FOAM OR DRY CHEMICAL POWDER.
SPECIAL FIRE FIGHTING PROCEDURES: NO SPECIAL MENTION
UNUSUAL FIRE AND EXPLOSION HAZARDS:
TOXIC GASES (CARBON MONOXIDE, NITROGEN OXIDES AND SULFUR OXIDE) WILL FORM
UPON COMBUSTION.
| SECTION V - REACTIVITY DATA | |
STABILITY:
UNSTABLE ( )
STABLE (X)
CONDITION TO AVOID:
INCOMPATIBILITY (MATERIALS TO AVOID):
HAZARDOUS DECOMPOSITION OR BYPRODUCTS:
HAZARDOUS POLYMERIZATION:
MAY OCCUR ( )
MAY NOT OCCUR (X)
CONDITION TO AVOID:
| SECTION VI - HEALTH HAZARD DATA | |
ROUTE(S) OF ENTRY:
INHALATION?: YES
SKIN?: YES
INGESTION?: YES
HEALTH HAZARDS (ACUTE AND CHROMIC): UNKNOWN
CARCINOGENIC:
NTP?: NONE
IARC MONOGRAPHS?: NONE
OSHA REGULATED?: NONE
SIGNS AND SYMPTOMS OF EXPOSURE: NOT APPLICABLE IN NORMAL USE.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: UNKNOWN
EMERGENCY AND FIRST AID PROCEDURE:
ROUT OF ENTRY EMERGENCY PROCEDURES SEEK MEDICAL ADVICE
INHALATION IF HE/SHE HAS SUBJECTIVE AND (X)
OBJECTIVE SYMPTOMS, MOVE
HIM/HER TO A PLACE FRESH AIR.
EYES GENTLY RINSE THE AFFECTED EYES (X)
WITH CLEAN WATER FOR AT LEAST
15 MINUTES.
SKIN RINSE WITH RUNNING WATER AND SOAP. ( )
INGESTION IF THE VICTIM STOPS BREATHING, WIPE (X)
AWAY ANY REMAINING MATERIAL IN THE
MOUTH AND CLEAR THE AIRWAY AND
ADMINISTER ARTIFICIAL RESPIRATION.
| SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE | |
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED.:
THE INK IS NOT SPILLED SO THAT IT SOAKED INTO THE INK RESERVOIR BY NORMAL
HANDLING. IN THE CASE OF STUCK TO THE SKIN, RINSE WITH RUNNING WATER AND
SOAP.
WASTE DISPOSAL METHOD: FOLLOW ALL REGULATIONS IN YOUR COUNTRY.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING:
KEEP AWAY HIGH TEMPERATURE OR DIRECT SUNLIGHT.
OTHER PRECAUTIONS: KEEP AWAY A STRONG ACID.
| SECTION VIII - CONTROL MEASURES | |
RESPIRATORY PROTECTION (SPECIFY TYPE): NOT NECESSARY
VENTILATION:
LOCAL EXHAUST: NOT NECESSARY
MECHANICAL (GENERAL): NOT NECESSARY
SPECIAL: NOT NECESSARY
OTHER: NOT NECESSARY
PROTECTIVE GLOVES: NOT NECESSARY
EYE PROTECTION: NOT NECESSARY
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: NOT NECESSARY
WORK / HYGIENIC PRACTICES:
IN THE CASE OF STUCK TO THE SKIN, RINSE WITH RUNNING WATER AND SOAP.
THIS INFORMATION HEREIN IS GIVEN GOOD FAITH, BUT NO WARRANTY, EXPRESSED OR
IMPLIED IS MADE.
N.A.: NOT APPLICABLE
N.D.: NOT DETERMINED