| Common Name: | DETAIL 46-501 |
| Manufacturer: | MYERS TIRE SUPPLY |
| SDS Revision Date: | 1/23/2001 |
| SDS Format: | No Format Specified |
| Item Number(s): | 4LCA3 |
| Manufacturer Model Number(s): |
SDS Table of Contents
Click the desired link below to jump directly to that section in the SDS.
MATERIAL SAFETY DATA SHEET
MYERS TIRE DETAIL 46-501
VERSION DATE: 01/23/01
| 1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION |  |
PRODUCT NAME: MYERS TIRE DETAIL 46-501
COMPANY ID:
MYERS TIRE SUPPLY
1293 S. MAIN ST.
AKRON, OH 44301
(330)253-5592
| 2. COMPOSITION / INFORMATION ON INGREDIENTS | |
COMPONENT CAS # EXPOSURE LIMITS OTHER
ACGIH TLV OSHA PEL
WATER 7732-18-5 NONE NONE
ESTABLISHED ESTABLISHED
NJ TRADE SECRET # 80100382-5009P NONE NONE
REGISTRY ESTABLISHED ESTABLISHED
POLYETHYLENE 84133-50-6 NONE NONE
GLYCOL ETHERS ESTABLISHED ESTABLISHED
| 3. HAZARDS IDENTIFICATION | |
POTENTIAL ACUTE (SINGLE OR SHORT TERM) HEALTH EFFECTS OF OVEREXPOSURE:
EYE:
MAY CAUSE MODERATE TO SEVERE IRRITATION, EXPERIENCED AS DISCOMFORT OR
PAIN, EXCESS BLINKING AND TEARING, WITH EXCESS REDNESS AND SWELLING OF THE
CONJUCTIVA. CORNEAL INJURY MAY OCCUR.
SKIN:
SKIN CONTACT MAY CAUSE IRRITATION. SYMPTOMS MAY INCLUDE REDNESS, BURNING,
DRYING AND CRACKING, AND SKIN BURNS.
INGESTION:
IF SWALLOWED SYMPTOMS MAY INCLUDE:
GASTROINTESTINAL IRRITATION (SUCH AS NAUSEA, VOMITING, AND DIARRHEA).
IRRITATION OF MOUTH AND THROAT MAY OCCUR.
INHALATION:
INHALATION OF RESPIRABLE AEROSOLS OF A COMPONENT(S) IN THIS PRODUCT MAY
CAUSE SERIOUS TOXIC EFFECTS IN THE LUNGS, BASED ON ANIMAL STUDIES.
POTENTIAL CHRONIC (REPEATED OR LONG TERM) HEALTH EFFECTS OF OVEREXPOSURE:
NO CHRONIC HEALTH EFFECTS KNOWN.
THIS PRODUCT CONTAINS NO COMPONENTS LISTED AS CARCINOGENIC BY IARC, NTP,
OR OSHA 1910(Z)
MEDICAL CONDITIONS AGGRAVATED BY OVEREXPOSURE:
SKIN CONTACT MAY AGGRAVATE AN EXISTING DERMATITIS.
| 4. FIRST AID MEASURES | |
EYE:
IMMEDIATELY FLUSH EYES WITH PLENTY OF WATER FOR AT LEAST 15 MINUTES. GET
MEDICAL ATTENTION.
SKIN:
IN CASE OF SKIN CONTACT, WASH THOROUGHLY WITH SOAP AND WATER. IF
IRRITATION PERSISTS, OR IF CONTACT HAS BEEN PROLONGED, GET MEDICAL
ATTENTION.
INGESTION:
DO NOT INDUCE VOMITING. HAVE VICTIM DRINK 8 TO 10 OUNCES OF WATER TO
DILUTE THE MATERIAL IN THE STOMACH. OBTAIN MEDICAL ATTENTION IMMEDIATELY.
INHALATION: REMOVE AFFECTED PERSON TO FRESH AIR.
| 5. FIRE FIGHTING MEASURES | |
FIRE AND EXPLOSION HAZARDS:
IN EXTREME FIRE CONDITIONS THIS MATERIAL MAY PRESENT A FLOATING FIRE
HAZARD.
FIRE FIGHTING INSTRUCTIONS:
USE WATER SPRAY, FOAM, DRY CHEMICAL, OR CO2. FIRE FIGHTERS SHOULD WEAR
NORMAL PROTECTIVE EQUIPMENT AND POSITIVE-PRESSURE SELF-CONTAINED BREATHING
APPARATUS. DO NOT DIRECT A SOLID STREAM OF WATER OR FOAM INTO HOT BURNING
POOLS, THIS MAY CAUSE FROTHING AND INCREASE FIRE INTENSITY.
FLASH POINT: NONE DETECTED BY PENSKY-MARTENS CLOSED CUP ASTM D93
| 6. ACCIDENTAL RELEASE MEASURES | |
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED:
AVOID RUN-OFF INTO STORM SEWERS AND DITCHES WHICH MAY LEAD TO NATURAL
WATERWAYS. MATERIAL SHOULD BE RECOVERED, IF POSSIBLE, OR COLLECTED BY
ABSORBENT MATERIALS SUCH AS DRY CLAY, SAND OR SAWDUST. WEAR APPROPRIATE
CLOTHING.
| 7. HANDLING, STORAGE AND DISPOSAL | |
HANDLING:
AVOID CONTACT WITH EYES. AVOID PROLONGED OR REPEATED CONTACT WITH SKIN.
WASH THOROUGHLY AFTER HANDLING. DO NOT REMOVE OR DEFACE LABEL.
STORAGE:
KEEP FROM FREEZING. KEEP CONTAINERS TIGHTLY CLOSED WHEN NOT IN USE. STORE
IN A COOL, DRY AREA.
DISPOSAL: DISPOSE ACCORDING TO FEDERAL, STATE AND LOCAL REGULATIONS.
| 8. EXPOSURE CONTROLS / PERSONAL PROTECTION | |
ENGINEERING CONTROLS:
GENERAL (MECHANICAL) ROOM VENTILATION IS EXPECTED TO BE SATISFACTORY.
EYE PROTECTION:
THE USE OF SAFETY GLASSES IS RECOMMENDED TO PREVENT ACCIDENTAL EYE
CONTACT.
SKIN PROTECTION:
THE USE OF GLOVES IS RECOMMENDED TO PREVENT IRRITATION OF THE SKIN.
RESPIRATORY PROTECTION:
THE USE OF AN APPROVED DUST, FUME AND MIST RESPIRATOR DESIGNED FOR
EXPOSURE LIMITS LESS THAN 0.05 MG/M3 IS RECOMMENDED. RESPIRATOR IS NOT
REQUIRED IF RESPIRABLE AEROSOLS OR MISTS ARE NOT PRODUCED.
| 9. PHYSICAL AND CHEMICAL PROPERTIES | |
PRODUCT FORM: BULK LIQUID
APPEARANCE: MILKY-WHITE LIQUID
ODOR: MILD ODOR
SPECIFIC GRAVITY: 0.97 @ 70 DEG. F
VAPOR PRESSURE: NEGLIGIBLE
VAPOR DENSITY (AIR = 1): N/A
EVAPORATION RATE (BUTYL ACETATE = 1): <1
SOLUBILITY IN WATER: SOLUBLE
BOILING POINT: APPROX. 212 DEG. F
pH:
| 10. STABILITY AND REACTIVITY | |
CHEMICAL STABILITY: STABLE
CONDITIONS TO AVOID: NONE
DECOMPOSITION PRODUCTS:
BURNING CAN PRODUCE THE FOLLOWING COMBUSTION PRODUCTS:
CARBON DIOXIDE AND CARBON MONOXIDE. OXIDES OF SILOXANES.
| 11. REGULATORY INFORMATION | |
SARA SECTION 313:
THIS PRODUCT CONTAINS THE FOLLOWING CHEMICALS THAT ARE SUBJECT TO RELEASE
REPORTING REQUIREMENTS UNDER SECTION 313 OF SARA TITLE III.
CHEMICAL NAME CAS # % BY WEIGHT
GLYCOL ETHER NA 3-4%
TSCA STATUS:
ALL COMPONENTS OF THIS PRODUCT ARE LISTED ON THE TSCA INVENTORY
CA PROPOSITION 65:
WARNING:
THIS PRODUCT CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE
CANCER.
CHEMICAL NAME CAS #
NO COMPONENTS LISTED IN THIS SECTION
WARNING:
THIS PRODUCT CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE
BIRTH DEFECTS.
CHEMICAL NAME CAS #
NO COMPONENTS LISTED IN THIS SECTION
03/02/01