| Common Name: | NANSULATE - NANOBOOST |
| Manufacturer: | INDUSTRIAL NANOTECH |
| SDS Revision Date: | 12/3/2009 |
| SDS Format: | No Format Specified |
| Item Number(s): | 5JET5 |
| Manufacturer Model Number(s): |
SDS Table of Contents
Click the desired link below to jump directly to that section in the SDS.
INI
INDUSTRIAL NANOTECH INC
THE GLOBAL LEADER IN NANOSCIENCE SOLUTIONS
MATERIAL SAFETY DATA SHEET
| SECTION 1: PRODUCT AND COMPANY IDENTIFICATION |  |
PRODUCT NAME: NANSULATE - NANOBOOST
SUPPLIER:
INDUSTRIAL NANOTECH INC.
1925 TRADE CENTER WAY - SUITE 1
NAPLES, FLORIDA 34108
EMERGENCY PHONE: 1(800)767-3998
FAX PHONE: 1(239)254-1381
PRODUCT USE: PAINT / COATING / LIQUID INSULATION
PREPARED BY: FRANCESCA CROLLEY
REV: 12/03/2009
| SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS | |
INGREDIENT CAS NO. WT/ WT %
DIPROPYLENE - GLYCOL - MONOBUTYL - ETHER 29911-28-2 5.0 - 10.0
STYRENE - ACRYLIC - COPOLYMER UNKNOWN 10.0 - 40.0
HYDRO-NM - OXIDE UNKNOWN 1.0 - 10.0
| SECTION 3: HAZARDS IDENTIFICATION | |
EMERGENCY OVERVIEW:
THIS MATERIAL IS A PAINT / COATING. IT IS A STABLE, NON-FLAMMABLE,
TRANSLUCENT LIQUID WITH A FLASHPOINT OVER 200F.
ROUTES OF ENTRY: EYE CONTACT, SKIN CONTACT, INHALATION
POTENTIAL HEALTH EFFECTS:
EYES: MAY CAUSE EYE IRRITATION
SKIN: PROLONGED SKIN CONTACT MAY CAUSE IRRITATION
INHALATION: HIGH VAPOR CONCENTRATIONS MAY CAUSE RESPIRATORY IRRITATION.
INGESTION:
ALTHOUGH INGESTION IS NOT CONSIDERED A SIGNIFICANT ROUTE OF ENTRY,
GASTROINTESTINAL IRRITATION AND NAUSEA MAY OCCUR IF SWALLOWED.
| SECTION 4: FIRST AID MEASURES | |
EYES: FLUSH EYE WITH WATER FOR 15 MINUTES, SEEK MEDICAL ATTENTION
SKIN: WASH WITH SOAP AND WATER, SEEK MEDICAL ATTENTION IF SYMPTOMS OCCUR
INGESTION: IF SWALLOWED, CALL POISON CONTROL & SEEK MEDICAL ATTENTION
INHALATION:
THIS MATERIAL IS CONSIDERED NON HAZARDOUS. IF EXPOSED TO EXCESSIVE LEVELS
OF VAPOR, REMOVE VICTIM TO FRESH AIR AND SEEK MEDICAL ATTENTION IF COUGH
OR OTHER SYMPTOMS EXIST.
NOTES TO PHYSICIANS OR FIRST AID PROVIDERS:
THIS MATERIAL IS NON-TOXIC. A SMALL QUANTITY (1 - TABLESPOON) IS UN-LIKELY
TO CAUSE HARM.
| SECTION 5: FIRE-FIGHTING MEASURES | |
THIS MATERIAL IN LIQUID FORM WILL NOT BURN. THE DRIED PAINT FILM MAY BURN
IN A FIRE.
FLASH POINT:
F: >200
C: >100
EXTINGUISHING MEDIA:
USE WATER SPRAY, FOAM, OR CARBON DIOXIDE WHEN FIGHTING FIRES
PROTECTION TO FIRE FIGHTERS:
AS IN ANY FIRE, WEAR SELF-CONTAINED BREATHING APPARATUS IN PRESSURE DEMAND
MODE AND FULL PROTECTIVE GEAR.
| SECTION 6: ACCIDENTAL RELEASE MEASURES | |
ACCIDENTAL RELEASE MEASURES:
KEEP UNNECESSARY PEOPLE AWAY. DIKE AND CONTAIN SPILL WITH INERT MATERIAL
(SAND, DIRT, ETC.) TRANSFER LIQUID TO A SAFE CONTAINER FOR RECOVERY OR
PROPER DISPOSAL, OR ABSORB MATERIAL WITH ABSORBENT MATERIALS SUCH AS KITTY
LITTER AND PLACE INTO CONTAINERS FOR PROPER DISPOSAL. KEEP SPILL OUT OF
SEWERS, DRAINS AND OPEN BODIES OF WATER. FLOORS MAY BE EXTREMELY SLIPPERY
AND HAZARDOUS; EXERCISE EXTREME CAUTION TO AVOID FALLS DURING CLEANUP.
| SECTION 7: HANDLING AND STORAGE | |
HANDLING:
AVOID CONTACT WITH EYES, SKIN, AND CLOTHING. KEEP AWAY FROM CHILDREN
STORAGE: KEEP FROM FREEZING. IDEAL TEMP RANGE = 40F TO 90F MAX.
| SECTION 8: EXPOSURE CONTROLS / PERSONAL PROTECTION | |
VENTILATION: USE ADEQUATE VENTILATION TO AVOID VAPOR CONCENTRATIONS
RESPIRATORY PROTECTION:
NONE REQUIRED UNDER NORMAL CONDITIONS, IF VAPOR EXPOSURE CAUSES DISCOMFORT,
AND IN AREAS OF POOR VENTILATION, USE NIOSH APPROVED RESPIRATOR.
EYE PROTECTION:
WEAR SAFETY GLASSES OR FACE SHIELD TO PROTECT EYE AND FACE CONTACT
SKIN PROTECTION: WEAR GLOVES TO AVOID PROLONGED SKIN CONTACT
OTHER PROTECTIVE CLOTHING OR EQUIPMENT:
FOR BRIEF CONTACT, NO SPECIAL PRECAUTIONS OTHER THAN CLEAN BODY - COVERING
CLOTHING SHOULD BE NEEDED. WHEN PROLONGED OR FREQUENT REPEATED CONTACT WITH
THE MATERIAL COULD OCCUR, USE IMPERVIOUS PROTECTION SUCH AS A TYVEK SUIT.
WORK HYGIENIC PRACTICES:
WASH THOROUGHLY IMMEDIATELY AFTER HANDLING; PREVENT EYE CONTACT, PROLONGED
SKIN CONTACT, AND EXCESSIVE INHALATION.
| SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES | |
APPEARANCE: HEAVY TRANSLUCENT LIQUID
ODOR: NONDESCRIPT
PHYSICAL STATE: LIQUID, LOW VISCOSITY
pH AS SUPPLIED: 6 - 8
SPECIFIC GRAVITY: 1.033
SOLUBILITY IN H2O: APPRECIABLE
| SECTION 10: STABILITY AND REACTIVITY | |
STABILITY: THIS PRODUCT IS STABLE UNDER NORMAL STORAGE CONDITIONS
CONDITIONS TO AVOID: NONE KNOWN
INCOMPATIBILITY: NONE KNOWN
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR
| SECTION 11: TOXICOLOGICAL INFORMATION | |
TOXICOLOGICAL INFORMATION:
THIS PRODUCT IS NOT CONSIDERED A CARCINOGEN BY IARC OR NTP AND IS NOT
REGULATED AS A CARCINOGEN BY OSHA.
| SECTION 12: ECOLOGICAL INFORMATION | |
ECOLOGICAL INFORMATION: NO DATA AVAILABLE
| SECTION 13: DISPOSAL CONSIDERATIONS | |
WASTE DISPOSAL METHOD:
REVIEW ALL STATE, FEDERAL AND LOCAL REGULATIONS REGARDING HEALTH AND
DISPOSAL FOR APPROPRIATE PROCEDURES. PRODUCT DISPOSED OF IN "AS SOLD
CONDITION" IS NOT A HAZARDOUS WASTE UNDER FEDERAL RCRA REGULATIONS.
LANDFILLING OF FREE LIQUID IS NOT RECOMMENDED.
| SECTION 14: TRANSPORT INFORMATION | |
U.S. DEPARTMENT OF TRANSPORTATION:
PROPER SHIPPING NAME: NOT REGULATED
HAZARD CLASS: N/A
ID NUMBER: N/A
PACKING GROUP: N/A
LABEL STATEMENT: N/A
| SECTION 15: REGULATORY INFORMATION | |
U.S. FEDERAL REGULATIONS:
TSCA (TOXIC SUBSTANCE CONTROL ACT):
THE CHEMICAL SUBSTANCES IN THIS PRODUCT ARE ON THE TSCA SECTION 8
INVENTORY. THIS PRODUCT CONTAINS THE FOLLOWING CHEMICAL SUBSTANCES SUBJECT
TO THE REPORTING REQUIREMENTS OF TSCA 12(B) IF EXPORTED FROM THE UNITED
STATES: NONE
SARA SECTION 313:
THIS PRODUCT CONTAINS THE FOLLOWING SUBSTANCES SUBJECT TO THE REPORTING
REQUIREMENTS OF SECTION 313 AND 40 CFR PART 372:
CHEMICAL NAME CAS NUMBER WT/WT % IS LESS THAN
DIPROPYLENE GLYCOL MONOBUTYL ETHER 29911-28-2 5.0-10.0
CANADIAN WHMIS:
THIS MSDS HAS BEEN PREPARED IN COMPLIANCE WITH CONTROLLED PRODUCT
REGULATIONS EXCEPT FOR USE OF THE 16 HEADINGS.
CANADIAN WHMIS CLASS: NO INFORMATION.
COMPONENT RCRA CLASSIFICATIONS: NO INFORMATION.
COMPONENT RCRA CODES: NO INFORMATION.
CERCLA RQ VALUE (MINIMUM): NO INFORMATION.
HMIS RATINGS:
HEALTH 1
FLAMMABILITY 0
REACTIVITY 0
VOLATILE ORGANIC COMPOUNDS (VOCS): 100 GRAMS/LTR (CALCULATED)
DISCLAIMER:
TO THE BEST OF OUR KNOWLEDGE, THE INFORMATION CONTAINED IN THIS MSDS IS
ACCURATE OR IS OBTAINED FROM SOURCES BELIEVED TO BE ACCURATE. NO LIABILITY,
EXPRESSED OR IMPLIED, IS ASSUMED FOR THE ACCURACY OR COMPLETENESS OF THE
INFORMATION CONTAINED HEREIN. BUYER ASSUMES LIABILITY IN ITS USE OF THIS
MATERIAL.