| Common Name: | LEMON LIME |
| Manufacturer: | RUBBERMAID COMMERCIAL PRODUCTS |
| SDS Revision Date: | 2/9/2006 |
| SDS Format: | No Format Specified |
| Item Number(s): | 19MG94, 8DPV5 |
| Manufacturer Model Number(s): |
SDS Table of Contents
Click the desired link below to jump directly to that section in the SDS.
RUBBERMAID(R*) COMMERCIAL PRODUCTS
MATERIAL SAFETY DATA SHEET
| I. GENERAL INFORMATION |  |
PRODUCT NAME OR NUMBER (AS IT APPEARS ON LABEL): LEMON LIME
RCP NUMBER: FG 9C94 00
AROMATECH REFERENCE NUMBER: 5035806
MANUFACTURER'S NAME: RUBBERMAID COMMERCIAL PRODUCTS LLC
ADDRESS (NUMBER, STREET, CITY, STATE AND ZIP CODE):
3124 VALLEY AVENUE
WINCHESTER, VA 22601
EMERGENCY TELEPHONE NO.:
EMERGENCY PHONE#: 1-800-255-3924 (AROMA TECH)
THIS PRODUCTS EMERGENCY CODE IS: 2
DATE OF LAST REVISION: 02/09/06
MANUFACTURER'S D-U-N-S NO.: NA
ADDITIONAL HAZARD CLASSES (AS APPLICABLE):
HEALTH 1
FLAMMABILITY 2
REACTIVITY 0
PERSONAL PROTECTION C
| II. INGREDIENTS (LIST ALL INGREDIENTS) 100% NEEDED | |
CAS REGISTRY # %W CHEMICAL GROUP (TSCA) LISTD AS A CARCINOGEN
IN NTP, IARC OR
OSHA 1910(Z) (SPECIFY)
VARIOUS <1 MISC. NO
66070-58-4 10 POLYMER NO
90622-57-4 78 ALIPHATIC HYDROCARBON NO
93-18-5 <1 CYCLIC ETHER NO
6485-40-1 <1 KETONE NO
80-54-6 10 ALDEHYDES NO
140-11-4 1 ESTERS NO
| III. PHYSICAL PROPERTIES | |
PHYSICAL STATE: CLEAR GEL
VAPOR PRESSURE @ 20 DEG. C: N/A
REFRACTIVE INDEX @ 25 DEG. C: N/A
VOC%: N/A
SPECIFIC GRAVITY @ 25 DEG. C: N/A
MELTING POINT (CC) (DEG. F): N/A
DENSITY @ 25 DEG. C: N/A
FLASH POINT (CC) (DEG. F): 142
COLOR: YELLOW
SOLUBLE IN: OIL
| IV. PHYSICAL HAZARDS | |
TYPE OF HAZARD: COMBUSTIBLE
EXTINGUISHING MEDIA: FOAM, CO2, DRY CHEMICAL
SPECIAL FIRE FIGHTING PROCEDURES:
SELF CONTAINED BREATHING APPARATUS, PROTECTIVE CLOTHING
MATERIALS/CONDITIONS TO AVOID: OPEN FLAMES, EXCESSIVE HEAT/COLD
UNUSUAL FIRE, EXPLOSION HAZARDS: NONE FOUND
STABILITY: STABLE
| V. HEALTH HAZARDS | |
WARNING!
DIRECT CONTACT WITH EYE OR SKIN MAY CAUSE IRRITATION.
BREATHING CONCENTRATED VAPORS MAY CAUSE RESPIRATORY IRRITATION.
THRESHOLD LIMIT VALUE (TLV): NOT ESTABLISHED
OSHA PERMISSIBLE EXPOSURE LIMIT (PEL): NOT ESTABLISHED
PRIMARY ROUTE(S) OF ENTRY: SKIN CONTACT, INHALATION, INGESTION.
EFFECTS OF OVEREXPOSURE: NONE CURRENTLY KNOWN.
| VI. FIRST AID PROCEDURES | |
EYES:
IMMEDIATELY FLUSH EYES WITH LARGE QUANTITIES OF WATER FOR AT LEAST 15
MINUTES. REMOVE CONTACT LENSES. CALL A PHYSICIAN IF IRRITATION PERSISTS.
INHALATION:
REMOVE TO FRESH AIR. IF BREATHING HAS STOPPED OR IS IRREGULAR, ADMINISTER
ARTIFICIAL RESPIRATION AND OXYGEN. SEEK MEDICAL ATTENTION.
SKIN:
WASH WITH SOAP AND WATER, FLUSH WITH LARGE QUANTITIES OF WATER. KEEP
CONTAMINATED CLOTHING AWAY FROM SKIN.
INGESTION:
IF SWALLOWED, IMMEDIATELY DILUTE WITH TWO 8 OUNCE GLASSES OF WATER OR MILK.
CONTACT PHYSICIAN IMMEDIATELY
| VII. HAZARDOUS INGREDIENTS INFORMATION | |
THE IDENTITY OF INDIVIDUAL COMPONENTS OF THIS MIXTURE IS PROPRIETARY
INFORMATION AND IS REGARDED TO BE A TRADE SECRET. THIS MIXTURE CONTAINS
NO SUSPECTED CARCINOGENS AS REPORTED BY NTP, ACGIH, OSHA OR IARC AT 0.1%
OR GREATER. ONE OR MORE OF THE COMPONENTS PRESENT IN GREATER THAN 1%
CONCENTRATION MAY PRESENT THE FOLLOWING HEALTH EFFECTS BASED ON EVALUATION
OF THE INDIVIDUAL COMPONENTS: MAY CAUSE EYE, SKIN OR RESPIRATORY
IRRITATION.
THE ABOVE EFFECTS ARE BASED ON EVALUATION OF INDIVIDUAL COMPONENTS AND THE
RELEVANCY TO THE MIXTURE AS A WHOLE OR TO HUMANS IS UNKNOWN. EXCESSIVE
EXPOSURE MAY CAUSE SIMILAR EFFECTS.
IN HUMANS, ONE OR MORE OF THE INDIVIDUAL COMPONENTS MAY CAUSE THE FOLLOWING
HEALTH EFFECTS: MAY BE IRRITATING TO EYES AND SKIN.
| VIII. PERSONAL PROTECTION | |
EYES:
THE USE OF SAFETY GLASSES IS RECOMMENDED. IF A MATERIAL IS TO BE HANDLED
IN A MANNER WHERE SPLASHING MAY OCCUR, THE USE OF SPLASH GOGGLES OR FACE
SHIELD IS RECOMMENDED.
RESPIRATORY:
IN WELL-VENTILATED AREAS, RESPIRATORY PROTECTION IS NOT NORMALLY REQUIRED.
IN CONFINED, POORLY VENTILATED AREAS, THE USE OF NIOSH APPROVED RESPIRATORY
PROTECTION IS RECOMMENDED.
EQUIPMENT APPAREL:
THE USE OF CHEMICAL RESISTANT GLOVES IS RECOMMENDED. ACCEPTABLE INDUSTRIAL
HYGIENE PRACTICES SHOULD BE MAINTAINED.
VENTILATION:
PROVIDE ADEQUATE VENTILATION. USE LOCAL EXHAUST FAN IF NECESSARY.
| IX. STORAGE AND HANDLING | |
IT IS RECOMMENDED THAT THIS MATERIAL BE STORED IN A COOL, WELL-VENTILATED
AREA, AVOIDING OPEN FLAMES OR OTHER SOURCES OF IGNITION.
| X. SPILL, RELEASE AND WASTE DISPOSAL PROCEDURES | |
SPILL OR RELEASE:
COVER LIQUIDS WITH ABSORPTIVE MATERIAL. SWEEP SPILLED MATERIAL AND DISCARD
IN APPROVED DISPOSAL CONTAINER.
DISPOSAL PROCEDURES:
USED CONTAINERS MAY CONTAIN FLAMMABLE OR COMBUSTIBLE RESIDUE. DISPOSE OF IN
ACCORDANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS.
| XI. TOXIC SUBSTANCES AND CONTROL ACT | |
THE COMPONENTS OF THIS PRODUCT ARE FOUND IN THE TSCA INVENTORY.
THIS PRODUCT MEETS CURRENT RIFM/IFRA GUIDELINES FOR:
SKIN CONTACTING PRODUCTS UP TO A MAXIMUM CONCENTRATION OF 100%
NON-SKIN CONTACTING PRODUCTS UP TO A MAXIMUM CONCENTRATION OF 100%
| XII. SUPERFUND AMENDMENTS AND REAUTHORIZATION | |
ACT (SARA) TITLE III NOTICE
THIS PRODUCT COMPLIES WITH TSCA INVENTORY REQUIREMENTS. THE POLYMER
COMPONENT IS ELIGIBLE FOR THE TSCA POLYMER EXEMPTION AND, AS SUCH, IS BEING
MANUFACTURED/IMPORTED UNDER THE TERMS OF THE EXEMPTION AT 40 CFR 723.250