| Common Name: | ULTRA VIOLET |
| Manufacturer: | W.W. GRAINGER |
| SDS Revision Date: | 10/2/2009 |
| SDS Format: | No Format Specified |
| Item Number(s): | 6RRG8 |
| Manufacturer Model Number(s): |
SDS Table of Contents
Click the desired link below to jump directly to that section in the SDS.
MATERIAL SAFETY DATA SHEET
HMIS(R*):
HEALTH 2
FLAMMABILITY 2
REACTIVITY 0
PERSONAL PROTECTION B
| SECTION 1 CHEMICAL PRODUCT AND COMPANY IDENTIFICATION |  |
IDENTITY: ULTRA VIOLET
ITEM NO.: 91195, 82195
OTHER NAMES: 916
FORMULA: ER195
NOTE:
BLANK SPACES ARE NOT PERMITTED. IF ANY ITEM IS NOT APPLICABLE, OR NO
INFORMATION IS AVAILABLE, THE SPACE MUST BE MARKED TO INDICATE THAT.
COMPANY NAME: W.W. GRAINGER, INC.
ADDRESS (NUMBER, STREET, CITY, STATE, AND ZIP CODE):
100 GRAINGER PARKWAY
LAKE FOREST, IL 60045
EMERGENCY TELEPHONE NUMBER: 1-800-228-5635
TELEPHONE NUMBER FOR INFORMATION: 1-847-565-5400
DATE PREPARED: 10/02/09
PRODUCT CLASS: SOLVENT BASED MARKER.
SIGNATURE OF PREPARER (OPTIONAL): REGULATORY DEPT.
| SECTION 2 COMPOSITION/INFORMATION ON INGREDIENTS | |
HAZARDOUS COMPONENTS CAS NO. %(OPT.)
(SPECIFIC CHEMICAL IDENTITY,
COMMON NAME(S))
AROMATIC HYDROCARBON 64742-95-6 85 - 95
1,2,4 TRIMETHYL BENZENE 95-63-6 10 - 20
ULTRA VIOLET DYE 7128-64-5 1 - 10
XYLENE 1330-20-7 1 - 5
HAZARDOUS COMPONENTS OSHA PEL ACGIH-TLV OTHER LIMITS
(SPECIFIC CHEMICAL RECOMMENDED
IDENTITY, COMMON NAME(S))
AROMATIC HYDROCARBON TWA: 100 PPM TWA: 100 PPM NO DATA
1,2,4 TRIMETHYL BENZENE TWA: 100 PPM TWA: 100 PPM NO DATA
ULTRA VIOLET DYE NO DATA NO DATA 10 MG/M3
NUISANCE DUST*
XYLENE TWA: 100 PPM TWA: 100 PPM NO DATA
* NUISANCE DUST AS FREE DUST ONLY, NOT AS BOUND IN PAINT OR INK.
| SECTION 3 HAZARDS IDENTIFICATION | |
EMERGENCY OVERVIEW: CLEAR THIN VISCOSITY LIQUID WITH AROMATIC ODOR.
WARNING!
COMBUSTIBLE LIQUID AND VAPOR. KEEP AWAY FROM HEAT SPARKS AND FLAMES. MAY
CAUSE EYE, SKIN AND RESPIRATORY TRACT IRRITATION. IF SWALLOWED DO NOT
INDUCE VOMITING. GET IMMEDIATE MEDICAL ATTENTION.
POTENTIAL HEALTH EFFECTS:
EYES: LIQUID IS MODERATELY IRRITATING TO THE EYES.
SKIN: LIQUID IS MILDLY IRRITATING TO THE SKIN.
INGESTION: INGESTION OF LIQUID MAY CAUSE VOMITING.
INHALATION:
HIGH CONCENTRATION OF VAPORS MAY PRODUCE IRRITATION OF THE RESPIRATORY
TRACT, HEADACHE, DIZZINESS, AND NAUSEA.
CHRONIC HEALTH EFFECTS:
PROLONGED OR REPEATED CONTACT MAY CAUSE SKIN SENSITIZATION OR DERMATITIS.
REPORTS HAVE ASSOCIATED REPEATED AND PROLONGED OCCUPATIONAL OVEREXPOSURE
TO SOLVENTS WITH IRREVERSIBLE BRAIN AND NERVOUS SYSTEM DAMAGE. INTENTIONAL
MISUSE BY DELIBERATELY CONCENTRATING OR INHALING THIS PRODUCT MAY BE
HARMFUL OR FATAL.
| SECTION 4 FIRST AID MEASURES | |
EYES:
IMMEDIATELY FLUSH EYES WITH PLENTY OF WATER FOR AT LEAST 15 MINUTES. GET
MEDICAL ATTENTION IMMEDIATELY.
INHALATION:
REMOVE TO FRESH AIR. IF NOT BREATHING, GIVE ARTIFICIAL RESPIRATION. IF
BREATHING IS DIFFICULT, GIVE OXYGEN. GET MEDICAL ATTENTION IMMEDIATELY.
SKIN:
FLUSH SKIN WITH PLENTY OF WATER. REMOVE CONTAMINATED CLOTHING AND SHOES.
INGESTION:
IF LARGE QUANTITIES OF THIS MATERIAL ARE SWALLOWED, GET IMMEDIATE MEDICAL
ATTENTION. DO NOT INDUCE VOMITING. NEVER GIVE ANYTHING BY MOUTH TO AN
UNCONSCIOUS PERSON.
| SECTION 5 FIRE FIGHTING MEASURES | |
FLASH POINT (METHOD USED): 108 DEG. F
FLAMMABLE LIMITS:
LEL: 1.9
UEL: 12.6
EXTINGUISHING MEDIA:
USE WATER FOG, FOAM, DRY CHEMICAL OR CO2. USE WATER SPRAY TO COOL
FIRE-EXPOSED CONTAINERS AND TO PROTECT PERSONNEL.
SPECIAL FIRE FIGHTING PROCEDURES:
KEEP CONTAINERS COOL AND VAPORS DOWN WITH WATER SPRAY. PREVENT SPILL FROM
ENTERING DRAINS, SEWERS, STREAMS OR OTHER BODIES OF WATER. IF RUN-OFF
OCCURS, NOTIFY PROPER AUTHORITIES. DO NOT ENTER CONFINED FIRE SPACE WITHOUT
FULL BUNKER GEAR (HELMET WITH FACE SHIELD, BUNKER COATS, GLOVES AND RUBBER
BOOTS), INCLUDING A POSITIVE PRESSURE NIOSH APPROVED SELF-CONTAINED
BREATHING APPARATUS.
UNUSUAL FIRE AND EXPLOSION HAZARDS:
VAPORS ARE HEAVIER THAN AIR AND MAY TRAVEL ALONG GROUND, OR BE MOVED BY
VENTILATION AND BE IGNITED BY IGNITION SOURCE.
| SECTION 6 ACCIDENTAL RELEASE MEASURES | |
SMALL SPILL:
ABSORB LIQUID WITH NON-COMBUSTIBLE FLOOR ABSORBENT AND PLACE IN NON-LEAKING
CONTAINER; SEAL PROPERLY AND DISPOSE OF PROPERLY IN COMPLIANCE WITH
FEDERAL, STATE, AND LOCAL REGULATIONS.
LARGE SPILL:
EVACUATE AREA OF UNPROTECTED PERSONNEL. ELIMINATE ALL IGNITION SOURCES.
STOP SPILL AT SOURCE IF SAFE TO DO SO. HANDLING EQUIPMENT MUST BE GROUNDED
TO PREVENT SPARKING. PREVENT SPILL FROM ENTERING DRAINS, SEWERS, STREAMS OR
OTHER BODIES OF WATER. IF RUN-OFF OCCURS, NOTIFY PROPER AUTHORITIES. PUMP
OR VACUUM TRANSFER SPILLED PRODUCT TO CLEAN CONTAINERS FOR RECOVERY. ABSORB
UNRECOVERABLE PRODUCT. TRANSFER CONTAMINATED ABSORBENT, SOIL AND OTHER
MATERIALS TO CONTAINERS FOR DISPOSAL. DISPOSE OF PROPERLY IN COMPLIANCE
WITH FEDERAL, STATE, AND LOCAL REGULATIONS.
| SECTION 7 HANDLING AND STORAGE | |
HANDLING:
EMPTY CONTAINERS RETAIN RESIDUE (LIQUID AND/OR VAPOR) AND CAN BE DANGEROUS.
DO NOT PRESSURIZE, CUT, WELD, BRAZE, SOLDER, DRILL, GRIND, OR EXPOSE SUCH
CONTAINERS TO HEAT, SPARKS, FLAMES, STATIC ELECTRICITY, OR OTHER SOURCES OF
IGNITION. MANY HOT ORGANIC CHEMICAL VAPORS OR MISTS ARE SUSCEPTIBLE TO
SUDDEN SPONTANEOUS COMBUSTION WHEN MIXED WITH AIR. IGNITION MAY OCCUR AT
TEMPERATURES BELOW THOSE PUBLISHED IN THE LITERATURE AS "AUTOIGNITION" OR
IGNITION TEMPERATURES. IGNITION TEMPERATURES DECREASE WITH INCREASING VAPOR
VOLUME AND VAPOR VOLUME AND VAPOR/AIR CONTACT TIME, AND ARE INFLUENCED BY
PRESSURE CHANGES. IGNITION OF ORGANIC CHEMICAL VAPORS MAY OCCUR AT TYPICAL
ELEVATED-TEMPERATURE PROCESS CONDITIONS, ESPECIALLY IN PROCESSES OPERATING
UNDER VACUUM IF SUBJECTED TO SUDDEN INGRESS OF AIR, OR OUTSIDE PROCESS
EQUIPMENT OPERATING UNDER ELEVATED PRESSURE IF SUDDEN ESCAPE OF VAPORS OR
MISTS TO THE ATMOSPHERE OCCURS. ANY PROPOSED USE OF THIS PRODUCT IN
ELEVATED-TEMPERATURE PROCESSES SHOULD BE THOROUGHLY EVALUATED TO ASSURE
THAT SAFE OPERATING CONDITIONS ARE ESTABLISHED AND MAINTAINED.
STORAGE:
KEEP AWAY FROM HEAT, SPARKS AND OPEN FLAMES. KEEP OUT OF REACH OF CHILDREN.
KEEP CONTAINER TIGHTLY SEALED WHEN NOT IN USE. STORE IN COOL,
WELL-VENTILATED PLACE AWAY FROM INCOMPATIBLE MATERIALS. INFORMATION ON THIS
MATERIAL SAFETY DATA SHEETS REFERS TO INK USED IN PENS AND MARKERS,
HOWEVER, IT APPLIES TO THESE INKS IN BULK. THE INKS ARE CONTAINED IN
CAPILLARY OR VALVE RESERVOIRS AND WILL NOT SPILL OR LEAK UNDER NORMAL
CONDITIONS.
| SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTION | |
RESPIRATORY PROTECTION (SPECIFY TYPE):
NOT USUALLY NECESSARY. USE WITH ADEQUATE VENTILATION. USE NIOSH/MSHA
APPROVED RESPIRATOR IF PELS OR TLVS ARE EXCEEDED.
ENGINEERING CONTROLS:
LOCAL EXHAUST: NOT USUALLY NEEDED
SPECIAL: NONE
MECHANICAL (GENERAL): YES
OTHER: NONE
PROTECTIVE GLOVES:
CHEMICAL RESISTANT GLOVES IF SKIN CONTACT IS POSSIBLE (CONSULT YOUR SAFETY
EQUIPMENT SUPPLIER).
EYE PROTECTION:
NOT NORMALLY REQUIRED IF USED AS INTENDED. WEAR CHEMICAL SPLASH GOGGLES IN
COMPLIANCE WITH OSHA REGULATION IF SPLASHING IS POSSIBLE.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT:
NOT USUALLY NECESSARY. FOR BULK MATERIAL, IF DIRECT CONTACT IS POSSIBLE,
WEAR APRON, BOOTS, FACE SHIELD, ETC. AS NEEDED.
WORK/HYGIENIC PRACTICES:
FOLLOW LABEL INSTRUCTIONS. WASH HANDS AFTER USE AND BEFORE EATING,
DRINKING, SMOKING, USING RESTROOMS, ETC.
| SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES | |
BOILING POINT: 318 TO 338 DEG. F
SPECIFIC GRAVITY (H2O = 1) @ 70 DEG. F: >1
VAPOR PRESSURE (MM-Hg @ 70 DEG. F): NO DATA
MELTING POINT: NO DATA
VAPOR DENSITY (AIR = 1): GREATER THAN ONE (1)
EVAPORATION RATE (BUTYL ACETATE = 1): LESS THAN ONE (1)
SOLUBILITY IN WATER: NEGLIGIBLE
pH: NO DATA
APPEARANCE AND ODOR: CLEAR THIN VISCOSITY LIQUID WITH AROMATIC ODOR.
VOC: THIS PRODUCT CONTAINS 809 GRAMS PER LITER OR 90.00% BY WEIGHT VOC'S.
| SECTION 10 STABILITY AND REACTIVITY | |
CHEMICAL STABILITY:
UNSTABLE ( )
STABLE (X)
CONDITIONS TO AVOID: NONE KNOWN.
INCOMPATIBILITY (MATERIALS TO AVOID):
STRONG OXIDIZING AND REDUCING AGENTS, STRONG ALKALIES AND STRONG ACIDS.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS:
CARBON DIOXIDE, CARBON MONOXIDE, SMOKE, SOOT AND VARIOUS ORGANIC OXIDATION
BY-PRODUCTS.
HAZARDOUS POLYMERIZATION:
MAY OCCUR ( )
WILL NOT OCCUR (X)
CONDITIONS TO AVOID: NO DATA
| SECTION 11 TOXICOLOGICAL INFORMATION | |
PLEASE REFER TO SECTION 3 FOR AVAILABLE INFORMATION ON POTENTIAL HEALTH
EFFECTS
| SECTION 12 ECOLOGICAL INFORMATION | |
NO SPECIFIC ECOLOGICAL DATA ARE AVAILABLE FOR THIS PRODUCT. PLEASE REFER TO
SECTION 6 FOR INFORMATION REGARDING ACCIDENTAL RELEASES AND SECTION 15 FOR
REGULATORY REPORTING INFORMATION.
| SECTION 13 DISPOSAL CONSIDERATIONS | |
DISPOSE OF IN ACCORDANCE WITH ALL APPLICABLE LOCAL, STATE AND FEDERAL
REGULATIONS.
| SECTION 14 TRANSPORT INFORMATION | |
(NOT MEANT TO BE ALL INCLUSIVE)
DOMESTIC HIGHWAY (CONTAINERS < 1 QUART ARE ORM-D):
PROPER SHIPPING NAME: INK/PAINT
HAZARD CLASS/SUBSIDIARY HAZARD: 3
UN/NA NO.: UN1263
PACKING GROUP: III
LABEL REQUIRED: COMBUSTIBLE LIQUID (2)
DOMESTIC AIR SHIPMENTS (PENS):
PROPER SHIPPING NAME: CONSUMER COMMODITY
HAZARD CLASS/SUBSIDIARY HAZARD: 9
UN/NA NO.: I.D. 8000
PACKING GROUP: NONE
LABEL REQUIRED: CLASS 9
| SECTION 15 REGULATORY INFORMATION | |
(NOT MEANT TO BE ALL INCLUSIVE - SELECTED REGULATIONS REPRESENTED)
U.S. FEDERAL REGULATIONS:
CARCINOGENICITY:
NTP?: NO
IARC MONOGRAPHS?: NO
OSHA REGULATED?: NO
OSHA:
HAZARDOUS BY DEFINITION OF HAZARD COMMUNICATION STANDARD
(29 CFR 1910.1200).
SECTION 313:
THIS PRODUCT CONTAINS XYLENE (1330-20-7) AND 1,2,4,TRIMETHYL BENZENE
(95-63-6) WHICH ARE LISTED AND MAY REQUIRE REPORTING UNDER SARA TITLE III
SEC. 313 IF USED OVER THE THRESHOLD REPORTING QUANTITY. THIS INFORMATION
MUST BE INCLUDED IN ALL MSDSS THAT ARE COPIED AND DISTRIBUTED FOR THIS
MATERIAL.
INTERNATIONAL REGULATIONS:
CANADIAN WHMIS: NOT WHMIS CONTROLLED (PENS)
BULK: CLASS B2, D2A
STATE REGULATIONS:
CALIFORNIA PROPOSITION 65:
THIS PRODUCT CONTAINS A CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO CAUSE
CANCER. BENZENE, ETHYL BENZENE.
THIS PRODUCT CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE
BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. TOLUENE, BENZENE.
| SECTION 16 OTHER INFORMATION | |
MSDS STATUS:
REVISED SECTION(S): SECTION 15 HAS BEEN UPDATED.
10/2/09: UPDATED W/CURRENT DATE.
WARNING!
THE USE OF THIS PRODUCT IS BEYOND THE CONTROL OF THE MANUFACTURER AND
DISTRIBUTOR; THEREFORE, NO GUARANTEE, EXPRESSED OR IMPLIED, IS MADE AS TO
THE EFFECTS OF SUCH OR THE RESULTS TO BE OBTAINED IF NOT USED IN ACCORDANCE
WITH DIRECTIONS OR ESTABLISHED SAFE PRACTICE. THE USER MUST ASSUME ALL
RESPONSIBILITY, INCLUDING INJURY OR DAMAGE, RESULTING FROM ITS MISUSE AS
SUCH, OR IN COMBINATION WITH OTHER MATERIALS. THE MANUFACTURER AND
DISTRIBUTOR WARRANT ONLY THAT THIS PRODUCT MEETS THE SPECIFICATIONS FOR
SUCH PRODUCT. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED, AS TO DESCRIPTION, QUALITY, MERCHANTABILITY, FITNESS FOR ANY
PARTICULAR PURPOSE, PRODUCTIVENESS, OR ANY OTHER MATTER OF THIS PRODUCT.
THE MANUFACTURER AND DISTRIBUTOR SHALL BE IN NO WAY RESPONSIBLE FOR THE
IMPROPER USE OF THIS PRODUCT. THE SOLE AND EXCLUSIVE REMEDY AGAINST THE
MANUFACTURER AND DISTRIBUTOR FOR BREACH OF WARRANTY SHALL BE REIMBURSEMENT
OF THE PURCHASE PRICE OF THE PRODUCT IN THE EVENT THAT A DEFECTIVE
CONDITION OF THE PRODUCT SHALL BE FOUND TO EXIST. NO OTHER REMEDY
(INCLUDING BUT NOT LIMITED TO INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR
INJURY TO PERSON OR PROPERTY OR ANY OTHER INCIDENTAL OR CONSEQUENTIAL LOSS)
SHALL BE AVAILABLE.