| Common Name: | COATED ABRASIVE |
| Manufacturer: | SAINT-GOBAIN |
| SDS Revision Date: | 2/18/2011 |
| SDS Format: | No Format Specified |
| Item Number(s): | 4LL44, 4LL45, 4LL47, 4LL49, 4LL50, 4LL52 |
| Manufacturer Model Number(s): |
SDS Table of Contents
Click the desired link below to jump directly to that section in the SDS.
SAINT-GOBAIN ABRASIVES
| SECTION 1 - PRODUCT AND COMPANY IDENTIFICATION |  |
PRODUCT NAME: COATED ABRASIVE
MSDS MANUFACTURER NUMBER: CA_ALL
MANUFACTURER NAME: SAINT-GOBAIN ABRASIVES, INC.
ADDRESS:
1 NEW BOND STREET
WORCESTER, MA 01615
GENERAL PHONE NUMBER: 508-795-5000
EMERGENCY PHONE NUMBER: 508-795-5000
WEBSITE: WWW.SGABRASIVES.COM
MSDS CREATION DATE: NOVEMBER 01, 2011
MSDS REVISION DATE: FEBRUARY 18, 2011
NFPA:
1
0
1
HMIS:
HEALTH HAZARD 1
FIRE HAZARD 0
REACTIVITY 0
PERSONAL PROTECTION X
* CHRONIC HEALTH EFFECTS
| SECTION 2 - COMPOSITION/INFORMATION ON INGREDIENTS | |
CHEMICAL NAME CAS# INGREDIENT PERCENT EC NUM.
CRYSTALLINE SILICA, QUARTZ 14808-60-7 0 - 1 BY WEIGHT 238-878-4
NYLON NO DATA 10 - 30 BY WEIGHT
PROPRIETARY INGREDIENTS NO DATA 1 - 5 BY WEIGHT
MELAMINE FORMALDEHYDE 9003-08-1 1 - 5 BY WEIGHT
ALUMINUM OXIDE, NON-FIBROUS 1344-28-1 30 - 60 BY WEIGHT 215-691-6
PHENOL, POLYMER WITH 9003-35-4 10 - 30 BY WEIGHT
FORMALDEHYDE
ALUMINOSILICATE MINERAL 68476-25-5 5 - 10 BY WEIGHT 270-666-7
| SECTION 3 - HAZARDS IDENTIFICATION | |
POTENTIAL HEALTH EFFECTS:
EYE: DUST MAY CAUSE SLIGHT IRRITATION.
SKIN: DUST FROM THIS PRODUCT MAY CAUSE TEMPORARY MECHANICAL IRRITATION.
INHALATION:
DUSTS FROM THIS PRODUCT MAY CAUSE MECHANICAL IRRITATION OF THE NOSE,
THROAT AND RESPIRATORY TRACT.
INGESTION:
INGESTION OF THIS PRODUCT IS UNLIKELY. HOWEVER, INGESTION OF PRODUCT MAY
PRODUCE GASTROINTESTINAL IRRITATION AND DISTURBANCES.
CHRONIC HEALTH EFFECTS:
CHRONIC HEALTH EFFECTS ARE NOT EXPECTED AS LONG AS GOOD HYGIENE AND PROPER
SAFETY PRECAUTIONS ARE PRACTICED.
PHENOL, POLYMER WITH FORMALDEHYDE:
CHRONIC HEALTH EFFECTS:
DUST GENERATED FROM INTENDED USE MAY CONTAIN TRACE AMOUNTS OF PHENOL AND
FORMALDEHYDE WHICH UNDER EXCESSIVE EXPOSURE MAY CAUSE SKIN SENSITIZATION
AND AIRWAY OBSTRUCTION.
| SECTION 4 - FIRST AID MEASURES | |
EYE CONTACT:
IMMEDIATELY FLUSH EYES WITH PLENTY OF WATER FOR AT LEAST 15 TO 20 MINUTES.
ENSURE ADEQUATE FLUSHING OF THE EYES BY SEPARATING THE EYELIDS WITH
FINGERS. GET MEDICAL ATTENTION, IF IRRITATION OR SYMPTOMS OF OVEREXPOSURE
PERSISTS.
SKIN CONTACT:
IMMEDIATELY WASH SKIN WITH SOAP AND PLENTY OF WATER.
GET MEDICAL ATTENTION IF IRRITATION DEVELOPS OR PERSISTS.
INHALATION:
IF DUST FROM CUTTING OR DRILLING IS INHALED, REMOVE THE AFFECTED PERSON TO
FRESH AIR. IF SYMPTOMS PERSIST, GET MEDICAL ATTENTION.
INGESTION:
ACCIDENTAL INGESTION OF THIS MATERIAL IS UNLIKELY. IF THIS DOES OCCUR,
WATCH PERSON FOR SEVERAL DAYS TO MAKE SURE INTESTINAL BLOCKAGE DOES NOT
OCCUR IF SYMPTOMS PERSIST, CALL A PHYSICIAN.
NOTE TO PHYSICIANS: NO INFORMATION AVAILABLE.
| SECTION 5 - FIRE FIGHTING MEASURES | |
FLAMMABLE PROPERTIES: NON FLAMMABLE.
FLASH POINT: DOES NOT APPLY.
AUTO IGNITION TEMPERATURE: NOT DETERMINED.
LOWER FLAMMABLE/EXPLOSIVE LIMIT: NOT AVAILABLE.
UPPER FLAMMABLE/EXPLOSIVE LIMIT: NOT AVAILABLE.
EXTINGUISHING MEDIA:
USE ANY EXTINGUISHING MEDIA APPROPRIATE FOR THE SURROUNDING FIRES.
UNSUITABLE MEDIA: NONE.
PROTECTIVE EQUIPMENT:
AS IN ANY FIRE, WEAR SELF-CONTAINED BREATHING APPARATUS PRESSURE-DEMAND,
MSHA/NIOSH (APPROVED OR EQUIVALENT) AND FULL PROTECTIVE GEAR.
NFPA RATINGS:
NFPA HEALTH 1
NFPA FLAMMABILITY 0
NFPA REACTIVITY 1
NFPA OTHER
| SECTION 6 - ACCIDENTAL RELEASE MEASURES | |
METHODS FOR CONTAINMENT:
CONTAINMENT OF THIS MATERIAL SHOULD NOT BE NECESSARY.
METHODS FOR CLEANUP:
SHOVEL OR SWEEP UP FOR RE-USE OR DISPOSAL. AVOID CREATING DUSTY CONDITIONS.
EVALUATE RESIDUE TO DETERMINE IF IT IS A HAZARDOUS WASTE BY CHARACTERISTIC.
DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE, FEDERAL AND PROVINCIAL
REGULATIONS.
| SECTION 7 - HANDLING AND STORAGE | |
HANDLING: HANDLE WITH ADEQUATE VENTILATION FOR NUISANCE DUST.
STORAGE: NO SPECIAL STORAGE CONDITIONS REQUIRED.
HYGIENE PRACTICES: WEAR SUITABLE GLOVES AND EYE/FACE PROTECTION.
| SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION - EXPOSURE | |
GUIDELINES
ENGINEERING CONTROLS:
GENERAL DILUTION VENTILATION AND/OR LOCAL EXHAUST VENTILATION SHOULD BE
PROVIDED AS NECESSARY TO MAINTAIN EXPOSURES BELOW OCCUPATIONAL EXPOSURE
LIMITS.
EYE/FACE PROTECTION:
ALWAYS WEAR SAFETY GLASSES OR SOME TYPE OF EYE PROTECTION WHEN GRINDING.
SKIN PROTECTION DESCRIPTION:
PROTECTIVE GLOVES.
LONG SLEEVED SHIRT AND LONG PANTS.
RESPIRATORY PROTECTION:
WHEN WORKERS ARE FACING AIRBORNE PARTICULATE/DUST CONCENTRATIONS ABOVE
THE EXPOSURE LIMIT THEY MUST USE APPROPRIATE CERTIFIED RESPIRATORS.
A PROPERLY FITTED NIOSH APPROVED DISPOSABLE N 95 TYPE DUST RESPIRATOR
OR BETTER IS RECOMMENDED.
OTHER PROTECTIVE:
USE OF THIS PRODUCT MAY CREATE ELEVATED SOUND LEVELS. HEARING PROTECTION
SHOULD BE WORN WHERE REQUIRED (SEE OSHA 29 CFR 1910.134 AND OTHER
APPLICABLE REGULATIONS).
EXPOSURE GUIDELINES:
INGREDIENT GUIDELINE OSHA GUIDELINE ACGIH QUEBEC CANADA
CRYSTALLINE TLV-TWA: VEMP-TWA:
SILICA, QUARTZ 0.025 MG/M3 0.1 MG/M3
RESPIRABLE RESPIRABLE
FRACTION (R) FRACTION (R)
ALUMINUM PEL-TWA: TLV-TWA: VEMP-TWA:
OXIDE, NON- 5 MG/M3 10 MG/M3 10 MG/M3 TOTAL
FIBROUS RESPIRABLE PARTICULATE/DUST
FRACTION (R) (T)
PEL-TWA:
15 MG/M3 TOTAL
PARTICULATE/DUST (T)
INGREDIENT ONTARIO MEXICO BRITISH COLUMBIA ALBERTA
CANADA CANADA CANADA
CRYSTALLINE OEL-TWAEV: LMPE-PPT: OEL-TWA: OEL-TWA:
SILICA, QUARTZ 0.05 MG/M3 0.1 MG/M3 0.025 MG/M3 0.1
RESPIRABLE RESPIRABLE RESPIRABLE MG/M3
FRACTION (R) FRACTION (R) FRACTION (R) RESPIRABLE
FRACTION
(R)
ALUMINUM PEL- OEL-TWAEV: MPE-PPT: OEL-TWA: OEL-TWA:
OXIDE, NON- 10 MG/M3 0.1 MG/M3 3 MG/M3 10 MG/M3
FIBROUS TOTAL RESPIRABLE RESPIRABLE
PARTICULATE/ FRACTION (R) FRACTION (R)
DUST (T)
OEL-TWA:
10 MG/M3
OEL-TWA:
10 MG/M3 TOTAL
PARTICULATE/DUST
(T)
OEL-STEL:
20 MG/M3 TOTAL
PARTICULATE/DUST
(T)
| SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES | |
PHYSICAL STATE APPEARANCE: SOLID ARTICLE.
ODOR: ODORLESS
FLASH POINT: DOES NOT APPLY.
AUTO IGNITION TEMPERATURE: NOT DETERMINED.
| SECTION 10 - STABILITY AND REACTIVITY | |
CHEMICAL STABILITY: STABLE UNDER NORMAL CONDITIONS.
HAZARDOUS POLYMERIZATION: HAZARDOUS POLYMERIZATION DOES NOT OCCUR.
CONDITIONS TO AVOID: KEEP AWAY FROM HEAT, SPARKS, OR OPEN FLAME.
SPECIAL DECOMPOSITION PRODUCTS:
IN USE, DUST AND DECOMPOSING ODORS MAY BE GENERATED. IN MOST CASES, THE
MATERIAL REMOVED FROM THE WORKPLACE WILL BE SIGNIFICANTLY GREATER THAN THE
SANDPAPER COMPONENTS.
COOLANTS MAY PRODUCE OTHER DECOMPOSITION PRODUCTS.
THERMAL DECOMPOSITION MAY PRODUCE TRACE AMOUNTS OF AMMONIA AND
FORMALDEHYDE.
| SECTION 11 - TOXICOLOGICAL INFORMATION | |
ACUTE TOXICITY: THIS PRODUCT HAS NOT BEEN TESTED FOR ITS TOXICITY.
CRYSTALLINE SILICA, QUARTZ:
RTECS NUMBER: VV7330000
ALUMINUM OXIDE, NON-FIBROUS:
RTECS NUMBER: BD1200000
INHALATION:
INHALATION - RAT TCLO:
200 MG/M3/5H/28W (INTERMITTENT) (LUNGS, THORAX, OR RESPIRATION - STRUCTURAL
OR FUNCTIONAL CHANGE IN TRACHEA OR BRONCHI; LUNGS, THORAX, OR RESPIRATION -
CHRONIC PULMONARY EDEMA; RELATED TO CHRONIC DATA - DEATH) (RTECS)
PHENOL, POLYMER WITH FORMALDEHYDE:
RTECS NUMBER: SM8542500
SKIN:
ADMINISTRATION ONTO THE SKIN - RAT LD50:
>2 GM/KG (DETAILS OF TOXIC EFFECTS NOT REPORTED OTHER THAN LETHAL DOSE
VALUE) (RTECS)
INGESTION:
ORAL - RAT LD50:
>5 GM/KG (DETAILS OF TOXIC EFFECTS NOT REPORTED OTHER THAN LETHAL DOSE
VALUE) (RTECS)
| SECTION 12 - ECOLOGICAL INFORMATION | |
ECOTOXICITY: NO ECOTOXICITY DATA WAS FOUND FOR THE PRODUCT.
| SECTION 13 - DISPOSAL CONSIDERATIONS | |
WASTE DISPOSAL:
USE STANDARD LANDFILL METHODS CONSISTENT WITH APPLICABLE FEDERAL, STATE,
PROVINCIAL AND LOCAL LAWS.
| SECTION 14 - TRANSPORT INFORMATION | |
DOT SHIPPING NAME: NOT REGULATED AS HAZARDOUS MATERIAL FOR TRANSPORTATION.
DOT UN NUMBER: NOT REGULATED AS HAZARDOUS MATERIAL FOR TRANSPORTATION.
IATA SHIPPING NAME: NOT REGULATED AS HAZARDOUS MATERIAL FOR TRANSPORTATION.
CANADIAN SHIPPING NAME:
THIS PRODUCT IS NOT REGULATED UNDER THE TRANSPORTATION OF DANGEROUS
GOODS ACT. (CAN)
| SECTION 15 - REGULATORY INFORMATION | |
INVENTORY STATUS:
EINECS CANADA CANADA TSCA INVENTORY
NUMBER NDSL DSL STATUS
CRYSTALLINE SILICA, QUARTZ LISTED LISTED
ALUMINUM OXIDE, NON-FIBROUS LISTED LISTED
PHENOL, POLYMER WITH LISTED LISTED
FORMALDEHYDE
ALUMINOSILICATE MINERAL 270-666-7 LISTED LISTED
CRYSTALLINE SILICA, QUARTZ:
EC NUMBER: 238-878-4
ALUMINUM OXIDE, NON-FIBROUS:
EC NUMBER: 215-691-6
ALUMINOSILICATE MINERAL:
EC NUMBER: 270-666-7
STATE RIGHT TO KNOW:
PA MA NJ
CRYSTALLINE SILICA, QUARTZ LISTED LISTED
ALUMINUM OXIDE, NON- LISTED LISTED LISTED: NO HAZARDOUS LIST
FIBROUS SUBSTANCE NUMBER: 2891
| SECTION 16 - ADDITIONAL INFORMATION | |
HMIS HEALTH HAZARD 1
HMIS FIRE HAZARD 0
HMIS REACTIVITY 0
HMIS PERSONAL PROTECTION X
MSDS CREATION DATE: NOVEMBER 01, 2011
MSDS REVISION DATE: FEBRUARY 18, 2011
COPYRIGHT(C) 1996-2011 ACTIO CORPORATION. ALL RIGHTS RESERVED.
UPC NUMBER: 66261077700 CA_ALL