| Common Name: | CONTACT CLEANER |
| Manufacturer: | BLASTER CHEMICAL |
| SDS Revision Date: | 3/24/2009 |
| SDS Format: | No Format Specified |
| Item Number(s): | 16W544 |
| Manufacturer Model Number(s): |
SDS Table of Contents
Click the desired link below to jump directly to that section in the SDS.
MSDS
"BLASTER(R*)"
MATERIAL SAFETY DATA SHEET
THE BLASTER CORPORATION
CONTACT CLEANER
MSDS NUMBER: CC - AEROSOL
REVISION DATE: 03/24/09
| 1 PRODUCT AND COMPANY IDENTIFICATION |  |
PRODUCT NAME: CONTACT CLEANER
MSDS NUMBER: CC - AEROSOL
PRODUCT CODE: 16-CC
MANUFACTURER:
THE BLASTER CORPORATION
8500 SWEET VALLEY DRIVE
VALLEY VIEW, OHIO 44125
(216) 901-5800
FAX: (216) 901-5801
WWW.BLASTERPRODUCTS.COM
24 HOUR EMERGENCY CONTACT:
CHEMTREC: (800) 424-9300
REVISION DATE: 03/24/09
| 2 COMPOSITION/INFORMATION ON INGREDIENTS | |
HAZARDOUS INGREDIENTS CAS # PERCENT EXPOSURE LIMITS
n-PROPYL BROMIDE 106-94-5 >90% SEE SECTION 15
CARBON DIOXIDE 124-38-9 <3% OSHA (TWA) - 5000 PPM
ACGIH (TWA) - 5000 PPM
| 3 HAZARDS IDENTIFICATION | |
ROUTE OF ENTRY: EYES, SKIN, INHALATION, INGESTION
TARGET ORGANS:
INHALATION:
MAY IRRITATE THE NOSE, THROAT, AND LUNGS. EXPOSURE TO HIGH DOSES MAY CAUSE
CENTRAL NERVOUS SYSTEM DEPRESSION. SUCH DOSES MAY ALSO CAUSE ADVERSE
EFFECT IN LIVER, KIDNEY AND LUNG.
SKIN CONTACT: MAY CAUSE IRRITATION.
EYE CONTACT: MAY CAUSE IRRITATION.
INGESTION: LOW TOXICITY, NOT EXPECTED TO BE A HAZARD IN NORMAL USE.
MAY AGGRAVATE A PRE-EXISTING SKIN AND RESPIRATORY DISORDERS.
PHYSICAL HAZARD:
AEROSOL CONTAINERS ARE PRESSURIZED (EVEN WHEN EMPTY!) DO NOT EXPOSE TO
TEMPERATURES ABOVE 120 DEG. F. DO NOT PUNCTURE OR BURN CAN. FAILURE TO
OBSERVE THESE PRECAUTIONS MAY RESULT IN RAPID AND VIOLENT DECOMPRESSION
OF THE CONTAINER PRODUCING PROJECTILES AND ATOMIZATION OF THE LIQUID
CONTENTS.
NOTICE:
REPORTS HAVE ASSOCIATED REPEATED AND PROLONGED OCCUPATIONAL OVEREXPOSURE
TO SOLVENTS WITH PERMANENT BRAIN AND NERVOUS SYSTEM DAMAGE. INTENTIONAL
MISUSE BY DELIBERATELY CONCENTRATING AND INHALING THE CONTENTS MAY BE
HARMFUL OR FATAL.
| 4 FIRST AID MEASURES | |
INHALATION:
REMOVE TO FRESH AIR. IF NOT BREATHING, GIVE ARTIFICIAL RESPIRATION. IF
BREATHING IS DIFFICULT, GIVE OXYGEN. CONTINUE TO MONITOR. GET MEDICAL
ATTENTION.
SKIN CONTACT:
REMOVE CONTAMINATED CLOTHING IMMEDIATELY!
WASH SKIN WITH SOAP & WATER. IF IRRITATION PERSISTS, SEEK MEDIAL
ATTENTION.
EYE CONTACT:
FLUSH EYE(S) WITH WATER FOR 15 MINUTES. IF IRRITATION PERSISTS, SEEK
MEDICAL TREATMENT.
INGESTION: DO NOT INDUCE VOMITING. SEEK MEDICAL ATTENTION.
| 5 FIRE FIGHTING MEASURES | |
FLASHPOINT: NONE
AUTOIGNITION TEMPERATURE: APPROX. 490 DEG. C
FLAMMABLE/EXPLOSION LIMITS: 3.8-9.50% BY VOLUME IN AIR
EXTINGUISHING MEDIA:
DRY CHEMICAL. CARBON DIOXIDE, ALCOHOL FOAM OR POLYMER FOAM (CLASS ABC, BC
FIRE EXTINGUISHER.) WATER MAY NOT BE EFFECTIVE.
UNUSUAL FIRE & EXPLOSION HAZARD:
LEVEL 3 AEROSOLS - CONTENTS UNDER PRESSURE
| 6 ACCIDENTAL RELEASE MEASURES | |
LEAKING AEROSOL CANS SHOULD BE PUT INTO SUITABLE CONTAINER UNTIL THE
INTERNAL PRESSURE HAS DISSIPATED. USE SUITABLE ABSORBENTS TO COLLECT
LIQUID PRODUCT. CONSULT REGULATIONS FOR THE DISPOSAL OF THE CONTAINER,
LIQUID AND ABSORBENTS.
| 7 HANDLING AND STORAGE | |
HANDLING PRECAUTIONS:
USE IN ACCORDANCE WITH GOOD INDUSTRIAL WORKPLACE PRACTICES. AVOID
UNNECESSARY CONTACT. WASH THOROUGHLY AFTER HANDLING. USE WITH GOOD
VENTILATION.
STORAGE REQUIREMENTS:
STORE IN A DRY PLACE AWAY FROM EXCESSIVE HEAT. STORE CONTAINERS WITH LIDS
ON AND PROPERLY LABELED.
DO NOT STORE AT TEMPERATURES ABOVE 120 DEGREES F.
| 8 EXPOSURE CONTROLS/PERSONAL PROTECTION | |
ENGINEERING CONTROLS:
EYE WASH STATIONS AND EMERGENCY SHOWERS SHOULD BE IMMEDIATELY AVAILABLE.
PROTECTIVE EQUIPMENT:
EYES AND FACE:
STANDARD SAFETY GLASSES WITH SPLASH SHIELDS TYPICALLY OFFER ADEQUATE
PROTECTION. WHERE EXCESSIVE SPLASHING OR SPRAYING IS POSSIBLE, A FACE
SHIELD SHOULD BE USED.
SKIN AND CLOTHING:
EXCESSIVE CONTACT SHOULD BE AVOIDED. NITRILE GLOVES, BOOTS AND APRONS WILL
PROVIDE ADEQUATE PROTECTION WHEN CONTACT CANNOT BE AVOIDED. REMOVE AND
WASH ANY CONTAMINATED CLOTHING IMMEDIATELY. WASH THOROUGHLY AFTER
HANDLING.
RESPIRATORY:
GOOD GENERAL VENTILATION SHOULD BE SUFFICIENT TO CONTROL AIRBORNE LEVELS.
MAINTAIN AIRBORNE CONCENTRATIONS BELOW OSHA ESTABLISHED EXPOSURE LIMITS OF
INGREDIENTS IN SECTION 2. USE NIOSH/MSHA APPROVED RESPIRATORS IF
VENTILATION IS NOT ADEQUATE.
EXPOSURE GUIDELINES/OTHER:
THE BLASTER CHEMICAL COMPANIES TAKES NOT RESPONSIBILITY FOR DETERMINING
WHAT MEASURES ARE REQUIRED FOR PERSONAL PROTECTION IN ANY SPECIFIC
APPLICATION. THIS INFORMATION SHOULD BE USED WITH DISCRETION.
| 9 PHYSICAL AND CHEMICAL PROPERTIES | |
APPEARANCE: CLEAR COLORLESS
PHYSICAL STATE: LIQUID
ODOR: STRONG ALCOHOL-LIKE
pH: NOT DETERMINED
VAPOR PRESSURE: APPROX. 110.8 MMHg @ 20 C
VAPOR DENSITY: >1 (AIR=1)
BOILING POINT: 158 F
FREEZING/MELTING PT.: NOT DETERMINED
SOLUBILITY: NEGLIGIBLE
SPEC GRAV./DENSITY: 1.31 - 1.32
HEAT VALUE: NOT DETERMINED
VOC: NOT DETERMINED
EVAP. RATE: 6.0 (nBuOAc=1.0)
BULK DENSITY: NOT DETERMINED
OCTANOL: NOT DETERMINED
MOLECULAR WEIGHT: NOT DETERMINED
PARTICLE SIZE: NOT APPLICABLE
SOFTENING POINT: NOT APPLICABLE
VISCOSITY: NOT DETERMINED
PERCENT VOLATILE: 100
SAT. VAP. CONCENTRATE.: NOT DETERMINED
MOLECULAR FORMULA: NOT DETERMINED
| 10 STABILITY AND REACTIVITY | |
STABILITY: THIS PRODUCT IS STABLE UNDER NORMAL CONDITIONS.
CONDITIONS TO AVOID: STORAGE TEMPERATURE ABOVE 120F
MATERIALS TO AVOID (INCOMPATABILITY):
AVOID STRONG MINERAL ACIDS AND STRONG OXIDIZING AGENTS. PROLONGED CONTACT
WITH ALUMINUM, MAGNESIUM AND ZINC METALS SHOULD BE AVOIDED.
HAZARDOUS DECOMPOSITION PRODUCTS:
HYDROGEN BROMIDE, CARBON MONOXIDE AND CARBON DIOXIDE.
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR.
| 11 TOXICOLOGICAL INFORMATION | |
n, PROPYL BROMIDE:
LD50/RAT, ORAL - 4260 MG/KG
LC50/RAT, INHALATION - 253000 MG/M3/0.5 HR
| 12 ECOLOGICAL INFORMATION | |
NO INFORMATION AVAILABLE.
| 13 DISPOSAL CONSIDERATIONS | |
USED OR UNUSED PRODUCT SHOULD BE DISPOSED OF IN ACCORDANCE WITH LOCAL,
STATE AND FEDERAL REGULATIONS. SOME SPECIAL REGULATIONS MAY EXIST FOR THE
DISPOSAL OF AEROSOL CONTAINERS.
EMPTY CONTAINERS MAY CONTAIN RESIDUAL PRESSURE AND CONTENTS. THEY SHOULD
BE HANDLED WITH THE SAME PRECAUTIONS AS THE PRODUCT.
| 14 TRANSPORT INFORMATION | |
DEPT. OF TRANSPORTATION (DOT):
THIS PRODUCT, AS IT LEAVES BLASTER'S FACILITIES, MEETS THE DEFINITIONS SET
FORTH IN CFR 49 PART 173.150C AS A "CONSUMER COMMODITY." ALLOWING FOR
CERTAIN EXCEPTIONS (173.156) FOR DOMESTIC SURFACE (GROUND) SHIPMENTS.
PROPER SHIPPING NAME: CONSUMER COMMODITY
HAZARD CLASS: ORM-D
INTERNATIONAL (IMDT-IATA):
PROPER SHIPPING NAME: AEROSOLS, LIMITED QUANTITIES
HAZARD CLASS: 2 NON-FLAMMABLE COMPRESSED GAS
UN NUMBER: 1950
| 15 REGULATORY INFORMATION | |
THE FOLLOWING IS A SELECTED LIST OF REGULATORY REQUIREMENTS. NOT ALL SUCH
REQUIREMENTS ARE IDENTIFIED. USERS OF THIS PRODUCT ARE SOLELY RESPONSIBLE
FOR COMPLIANCE WITH ALL APPLICABLE FEDERAL, STATE AND LOCAL REGULATIONS.
THIS PRODUCT CONTAINS n-PROPYL BROMIDE A SUBSTANCE LISTED IN CALIFORNIA'S
SAFE DRINKING WATER AND TOXIC ENFORCEMENT ACT OF 1986 - PROPOSITION 65
RIGHT TO KNOW, NJ & PA:
OCCUPATIONAL EXPOSURE LIMITS FOR n-PROPYL BROMIDE:
TOXICOLOGY EXCELLENCE FOR RISK ASSESSMENT REPORTS: 20 PPM
ICF CONSULTING GROUP REPORTS: 25 PPM
ENVIRONMENTAL PROTECTION AGENCY REPORTS: 25 PPM
ACGIH REPORTS: 10 PPM
SUPPLIER'S TWA: 25 PPM
ALL THE COMPONENTS OF THIS PRODUCT ARE LISTED ON THE TSCA INVENTORY.
| 16 OTHER INFORMATION | |
MANUFACTURER'S DISCLAIMER:
TO THE BEST OF OUR KNOWLEDGE, THE INFORMATION CONTAINED HEREIN IS
ACCURATE. HOWEVER, NEITHER THE BLASTER CHEMICAL COMPANIES NOR ANY OF
ITS SUBSIDIARIES ASSUMES ANY LIABILITY WHATSOEVER FOR THE ACCURACY OR
COMPLETENESS OF THE INFORMATION CONTAINED HEREIN. FINAL DETERMINATION OF
SUITABILITY OF ANY MATERIAL IS THE SOLE RESPONSIBILITY OF THE USER. ALL
MATERIALS MAY PRESENT UNKNOWN HAZARDS AND SHOULD BE USED WITH CAUTION.
ALTHOUGH CERTAIN HAZARDS ARE DESCRIBED HEREIN, WE CANNOT GUARANTEE THAT
THESE ARE THE ONLY HAZARD WHICH EXISTS.
HMIS RATINGS:
HEALTH 1
FIRE 0
REACTIVITY 0